Additional Information09
ProblemCause / Remedy
The analog audio is OK, butY Make sure that the Digital Out setting is set to On (page 53).
there appears to be no digitalY Check that the Dolby Digital, DTS and MPEG out settings
audio signal.(pages 53-54) are suitable for your amplifier/receiverNcheck the
instruction manual that came with your amplifier/receiver.
Y SACDs and some DVD-Audio discs do not output digital audio.
Listen through the playerOs analog audio outputs.
Noticeable difference in DVDY This is due to differences in the audio format and is not a
and CD volume.malfunction.
Cannot play multi-channelYMake sure that Audio Output Mode is set to 5.1 Channel
audio.(page 64).
YCheck that the Dolby Digital, DTS and MPEG Out settings
(pages 53-54) are suitable for your amplifier/receiverNcheck the
instruction manual that came with your amplifier/receiver.
Y DVD-Audio and SACDs do not output multichannel digital
audio. Listen through the playerOs analog outputs.
Y Check that the settings in the Speaker Installation screen are
correct (page 64).
Y Check the audio options available from the disc menu.
Cannot listen to high-samplingY Make sure that Linear PCM Out is set to Down Sample Off
rate audio through the digital(page 54).
output.Y As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to Down Sample Off, the player
automatically outputs the audio at 48 kHz. This is not a malfunc-
tion.
Cannot output 192kHz orY The player does not output digital audio at these sampling
176.4kHz digital audio.rates. The digital output is automatically downsampled.
Cannot output 96kHz orY Check that Linear PCM Out is set to Down Sample Off (page
88.2kHz digital audio.54).
Y Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automati-
cally downsampled.
No DTS audio output.Y If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set DTS Out to DTS 3 PCM.
If you do not do this, noise will be output when you play a DTS
disc.
Y If this unit is connected to a DTS-compatible amplifier or
decoder using a digital audio cable, check the amplifier settings,
and that the cable is properly connected.
77
En |
ACEC
