Additional InformationAdditional Information
When recorded on a VCR or passed through an AVNoticeable difference in DVD, SACD and CD volume.
selector, there is disturbance in the playback picture.DVDs, CDs and SACDs seem to play at different
This is not a malfunction.volumes.
\ Due to the playerOs copy protection circuits,\ This is a result of the different recording methods
connection of this device through a VCR or an AVused.
selector may prevent recording or cause picture\ The volume of SACD is about half that of CD.
problems..........................................................................................................................
.........................................................................................................................Audio mix does not sound right or sounds
Remote control operation is not possible.incomplete (for example, the dialog of the actors
The CONTROL IN jack on the player is being used.cannot be heard).
\ Point the remote control at the component that theAudio output selection is incorrect.
player is connected to (page 11).\ When O5.1 Channel� is selected, Dialog is not output
from the front left and right speakers. When O2
The remote control is too far from the player, or theChannel� is selected, sound is only output through
angle with the remote sensor is too wide.the front left and right speakers (page 21).
\ Be sure to operate the remote from a location within.........................................................................................................................
its operating range (page 8).
Caution
The batteries are exhausted.
Static electricity or other external influence may
\ Replace the exhausted batteries with all newcause malfunctioning of this unit. In this case,
batteries (page 8).
.........................................................................................................................unplugging the power cord and then re-plugging it in
will usually reset the unit for proper operation. If this
Audio is not output or is distorted.
does not correct the problem, please consult your
The Setup screen Audio 1 menu [Linear PCM Out]nearest PIONEER service center.
setting is set to ODown Sample Off�.
\ On DVDs that contain copy protection, it may not be
possible to play back the audio at 96 kHz. When this
type of disc is encountered, even if ODown Sample
Off� is selected, the player automatically outputs the
digital audio output at a compressed rate of 48 kHz.
This is not a malfunction.
\ Be sure to make analog audio connections as well as
digital connections (pages 14 and 18).
The disc is dirty.
\ Refer to ODisc Care� (page 66).
The connection plugs are not inserted fully into the
terminals or are not connected.
\ Check that all connection plugs are firmly inserted.
The connection plug or terminal is dirty.
\ Check that the plugs and terminals are wiped clean of
dirt, etc.
Audio cable connection is wrong.
\ Check to make sure that the audio cables are
connected correctly (pages 14 and 18).
Connection is made to the stereo amplifier�s PHONO
input terminal.
\ Change connection to any input terminal except
PHONO.
The pause mode is engaged.
\ Press PLAY 3 or PAUSE 8 to exit the pause mode.
Stereo amplifier operation is incorrect.
\ Check input (CD, AUX, etc.) selector to determine if it
is selected for DVD playback.
70
En |
ACEC
