DVD-116 Operating Instructions
7) Audio Output
connector for analog audio output, uses a Modex 70553 connector
Select the appropriate cable from the following chart:
PinNameFunction
1LLeft channel audio output
2GGround
3GGround
4RRight channel audio output
8) Device Configuration Jumper
set this jumper switch to select the drive use mode supporting the computer
(jumpered = ON; no jumpe =r OFF)
PinNameFunction
1
1MA*onDrive set to Master mode
2SLonDrive set to Slave mode
3CSonDrive set to Cable Select mode
4Reserved
5Reserved
9) Host IDE Interface
40-pin I/O connector in accordance with ATA specifications
10) DC Input
power supply input for DC +5 V and +12 V
PinNameFunction
1+12Power supply input for DC +12 V
2GGround
3GGround
4+5Power supply input for DC +5 V
4.3Region Code Information
The maximum number of times the Region Code may be chang5ed is), five (
including the initial setting. The fifth change becomes PERMANENT until the unit
is serviced and the counter is reset to 1.
Note: Region Codes are part of the DVD Standard, however, Region Codes on DVD
discs are optional. DVD discs with no specified Region Code may be played on any
player.
- 7 - |