Installation
ENGLISH
become hot to the touch and minor burns could
CAUTIONresult.
Y Do not install the amplifier on unstable places
Y Do not install in:such as the spare tire board.
NPlaces where it could injure the driver or pas-Y The best location for installation differs with the
sengers if the vehicle stops suddenly.car model and installation location. Secure the
NPlaces where it may interfere with the driver,amplifier at a sufficiently rigid location.
Y Make temporary connections first and check thatESPA?OLsuch as on the floor in front of the driverOs
seat.the amplifier and the system operate properly.
Y Make sure that wires are not caught in the slidingY After installing the amplifier, confirm that the
mechanism of the seats, resulting in a short-cir-
cuit.spare tire, jack and tools can be easily removed.
Y Confirm that no parts are behind the panel when
drilling a hole for installation of the amplifier.Example of installation on the floor
Protect all cables and important equipment such
as fuel lines, brake lines and electrical wiringmat or on the chassis
from damage.DEUTSCH
Y Install tapping screws in such a way that the1. Place the amplifier where it is to be
screw tip does not touch any wire. This is impor-
tant to prevent wires from being cut by vibrationinstalled. Insert the supplied tap-
of the car, which can result in fire.ping screws (4 � 18 mm) into the
Y DO NOT allow amplifier to come into contactscrew holes. Push on the screws with
with liquids due to, for example, the location
a screwdriver so they make marks
where the amplifier is installed. Electrical shock
could result. Also, amplifier and speaker damage,where the installation holes are toFRAN?AIS
smoke, and overheating could result from contactbe located.
with liquids. In addition, the amplifier surface and
the surface of any attached speakers could2. Drill 2.5 mm diameter holes at the
become hot to the touch and minor burns couldpoint marked, and install the ampli-
result.
Y To ensure proper installation, use the suppliedfier, either on the carpet or directly
parts in the manner specified. If any parts otherto the chassis.
ITALIANOthan the supplied ones are used, they may damage
internal parts of the amplifier, or they mayTapping-screws
become loose causing the amplifier to shut down.(4 � 18 mm)
Y Never replace the fuse with one of greater value
or rating than the original fuse. Use of an improp-
er fuse could result in overheating and smoke and
could cause damage to the product and injury
including burns.
NEDERLANDS
CAUTION:
To prevent malfunction and/or injury
Y To ensure proper heat dissipation of the amplifier,
be sure of the following during installation.
NAllow adequate space above the amplifier forDrill a 2.5 mm diameter hole
proper ventilation.Floor mat
NDo not cover the amplifier with a floor mat oror chassis
eiëëäaâcarpet.
Y DO NOT allow amplifier to come into contact
with liquids due to, for example, the location
where the amplifier is installed. Electrical shock
could result. Also, amplifier and speaker damage,
smoke, and overheating could result from contact
with liquids. In addition, the amplifier surface and
the surface of any attached speakers could
10 |
ACEC
