Chapter 2 Installing the LCD TVChapter 2 Installing the LCD TV
Cable TV (CATV) Connection
METHOD A:
Use a supplied antenna cable to connect the NTSC signal to the LCD TV?s TV CABLE
This reminder is provided to call the CATV system installer?s attention to Article 820-40 of the
terminal.
National Electrical Code (NEC) that provides guidelines for proper grounding and, in particular, ENGLISH
speciŢ es that the cable ground shall be connected to the grounding system of the building
accurately, or as close to the point of cable entry as possible. Use of this TV for other than
private viewing of programs broadcasted on UHF, VHF or transmitted by cable companies for
the use of the general public may require authorization from the broadcast/cable company, and/
TVHDTV
or program owner. CABLEAIR
VHF/UHF IN
v A 75-ohm coaxial cable connector is built into the set for easy hookup.
When connecting the 75-ohm coaxial cable to the set, connect the 75-
ohm cable into the ANT. terminal.
v Some cable TV companies o
signals of these premium pay channels are scrambled, a cable TV
converter/descrambler is generally provided to the subscriber by the
A
cable TV company. METHOD B:
Use a supplied antenna cable to connect the ATSC signal to the LCD TV?s
HDTV AIR terminal.
This converter/descrambler is necessary for normal viewing of scrambled channels.
(Set your TV to channel 3 or 4, typically one of these channels is used. If this is unknown,
consult your cable TV company.) Connect the AC power cord at the back of the TV and connect the power cord to wall
For more speciŢ c instructions on installing cable TV, consult your cable TV company. outlet.
One possible method of connecting the coverter/descrambler provided by your cable TV
company is shown in the diagram below.
TVHDTV
CABLEAIR
RF switch
(not included)VHF/UHF IN
A 2 set signal
OUTINsplitterCable TV Line
(not included)
B
Press the button on the remote to turn on the LCD TV.
Cable TV converter/
descrambler
VHF/UHF IN(not included)
Always disconnect the LCD TV from the main voltage when the LCD TV will
not be used for a long period of time. The POWER button on the front panel
is only used for switching the LCD TV into standby, it does not disconnect
the device from the main voltage. To completely disconnect the main
voltage, please remove the power plug from the socket.
v The RF switch (not included) is required to provide two inputs (A and B). Setting
the RF switch to position A allows viewing of all unscrambled channels by using
the TV channel keys.
Press the Input button on the remote to
v Setting the RF switch to position B allows viewing of all scrambled channels via display the Input List. Use the xy buttons to Input
the converter/descrambler by using the converter channel keys. TV(CABLE/AIR) D
select TV( METHOD A), or HDTV (METHOD HDTV (CABLE/AIR)
B), and press the OK button. VIDEO1 (SIDE)
VIDEO2 (REAR)
VIDEO3 (S-VIDEO)
VIDEO4 (YPbPr1)
VIDEO5 (YPbPr2)
VIDEO6 (HDMI)
COMPUTER (VGA)
1617 |
ACEC
