Troubleshooting
Cleaning the Printer
Cleaning the Friction PadCleaning the Charger
If the friction pad becomes dirty, mis-The charger requires cleaning when
feeds or multi-feeds of paper mightyour printouts appear dirty.
occur. In this case, clean the pad as
R CAUTION:
follows: ?When accessing the inside of the
ASlide the paper tray out until itmachine, do not touch any sec-
stops. After that, lift it slightly,tions other than those specified
then pull it out of the printer.in this manual. If you do, it might
Then remove the paper from theresult in receiving a burn or inju-
4paper tray.ry.
BClean the friction pad with a soft
AOpen the front cover by pushing
damp cloth. After wiping it with athe front cover release button.
damp cloth, wipe it with a dry
cloth to remove the water.
Important
r Do not use chemical cleaners or
organic solvents such as thinner
or benzene.
TFWX080E
Important
r Exposing the photoconductor
unit to light for too long can re-
duce its performance. Clean the
charger as quickly as possible.TFWY230E
BHold the inset grips (green part)
CLoad paper with the print side up
of the photoconductor unit, and
into the paper tray. While liftingpull the top side of the photocon-
the front side of the tray, insertductor unit forward.
the paper tray into the printer.
Then push in until it stops.
42TFWX250E |
ACEC
