Setting Originals
Setting one original at a time
(SADF) modeSetting Originals When Auto
Paper Select Cannot
ImportantRecognize the Size
r Hold the document from the front
When you wish to use Auto Reduce/
when setting it. If your hand cov-Enlarge when setting non-standard
ers the internal sensor, it will not
operate correctly and the original2size documents in the ADF, specify
could be damaged.the size of your original using the fol-
lowing procedure.
r When setting pages of documents
1 page at a time in the ADF usingImportant
Auto Paper Select and Auto Re-r Be sure to press the {Clear Modes}
duce/Enlarge, these featureskey after copying non-standard
adapt to the size of the scannedsize originals to clear any settings.
original.Not taking this precaution could
result in damage to originals set in
ASet one original face up into thethe ADF.
document feeder. Then, press the
{{{{Star}}}}t key.Limitation
The Auto Feed indicator is lit.r You cannot specify the original
size when using Auto Paper Select.
BSet the next original while the
Auto Feed indicator is lit.r Acceptable Document Sizes
Vertical:105 - 297mm
The second and subsequent origi-(4.1?-11.7?)
nals can be fed automatically with-Horizontal: 128 - 1,260mm
out pressing the {Star}t key.(5.0?-17.0?)
ASet the aligned originals face up
into the document feeder.
BAdjust the guide to the original
size.
Note
r You can adjust the time the ma-
chine waits before being ready
for the next original. See ?SADF
Auto Reset? in Ţ P.82 ?2. Input/
Output?.
29 |