CM-30_e.book 11 Z8 ???? ??e?? xýI
U xý9 V?p?? Â
Using a Microphone Stand
By using a mic stand, you can mount the CM-30 Mounting the CM-30 to a
at the optimal height for use as a monitor speaker
or simple PA device.mic stand
Requirements when using a mic standAlways have at least one other person assist you
when mounting the CM-30 on a mic stand, or
IAs shown in the diagram below, the mic when adjusting the height of the stand while the
standOs tripod must be extended to its CM-30 remains mounted on it.
maximum width (at least 63 cm/25 inches) 1.As shown in the diagram, place the CM-30
and the height must be less than 110 cm
(including the CM-30).upside down and rotate the mic stand to screw
it firmly into the CM-30Os mic stand holder.
*When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.
110 cm (43-5/16�)
or less
2.Open the tripod so itOs at full spread.
If the tripod is not fully opened, the stand
63 cm (24-13/16�) or morewill be unstable.
IUsing a mic stand that does not meet the 3.Grasp the CM-30 and mic stand, and place
them upright on the floor.
specifications above may result in damage to 4.Adjust the height of the mic stand as desired,
equipment or injury due to the stand tipping
over.but do not allow the height (including the
CM-30) to exceed 110 cm (approx. 43 inches).
IWhen using CM-30 with a mic stand, the 5.Firmly tighten the hardware of the mic stand so
mic stand must be carefully placed so it is
level and sure to remain stable.that the CM-30 does not wobble to left or right.
ICables connected to CM-30 should be given
enough slack to prevent accidents that might
result from someone tripping over them.
ITo prevent accidents due to falls, do not
place any object on the CM-30 when itOs
mounted on a mic stand.
*Be careful not to pinch your fingers while performing
these steps.
11 |
ACEC
