vc1_for_XT_e1 42 Z8 r
Overview of the VC-1
TVF (Time Variant Filter)
This fitter passes lower frequency harmonics and cuts off the higher ones. By changing the cutoff point
and the resonance, the waveform changes.
4Cutoff Frequency
This sets the cutoff point. The cutoff point can be controlled by TVF ENV and any LFO (= Common
parameter).
5Resonance
This emphasizes the cut off point, making more unusual or electronic sounds.
TVA (Time Variant Amplifier)
This controls the volume of the Partial.
6Level
This determines the volume of the sound. When a synthesizer sound generators used, the level can be
controlled with the TVF ENV and LFO (Common Parameter) . When a PCM sound generator is used,
the TVA ENV controls the level.
ENV (Envelope Generator)
This generators a control signal (envelope curve) which controls the pitch, timbre and volume of each
Partial (sound generator).
7P-ENV
This is the ENV which controls pitch. It can be set for two selected Partial at once.
8TVF ENV
This ENV controls the cutoff point, and can be set for each Partial separately.
9TVA ENV
This ENV controls the volume level. This is can be set for each Partial separately.
LFO (Low Frequency)
This oscillator generates low frequencies only.
Any of the three LFOOs can be used for the two partials, Vibrato, PWM growl or tremolo effects can be
obtained using these LFOOs
* A different LFO can be used for each section or a Partial Parameters.
10LFO-1
This can control Pitch, Pulse Width, Cutoff Frequency or Level.
11LFO-2
This can control Pulse Width, Cutoff Frequency or Level.
12LFO-3
This can control Pulse Width, Cutoff Frequency or Level.
42 |