Guided Tour - UM1 ReceivSamson erAirLine
1: A/B Receiver LEDs - When signal is being received, one of these will be lit orange,
ENGLISH
1 231
showing you whether the (left) A or (right) B receiver is currently being used. The
UM1 constantly scans its two antennas and automatically selects whichever is receiving
the strongest, clearest signal. This True Diversity switching is completely inaudible, but
AUHF MICRO DIVERSITY RECEIVERB
it effectively increases overall range while virtually eliminating potential interference
LOWMIDHIGHPEAK800MHz
and phase cancellation problems.
2: Meter - This set of three multicolor LEDs acts as a meter, indicating either battery
power or the strength of the incoming RF signal. This meter - can also be disabled alto
gether to conserve battery power. See #15 on page 9 for more information.
4
MINMAX
3: Peak LED - This LED lights red when output signal from the UM1 is 5 at the onset of SQ LEVELPOWERON
clipping (that is, when it is on the verge of being distorted). If you see this light during
+
operation, move the microphone further away or lower the output -level of your instru
6
ment or transmitter. For more information, see the section entitled Setting Up and
-
Using the AirLine System on page 14 in this manual.
7
4: Power switch - Use this to turn the UM1 power on and off.
5: SQ (Squelch) Level control - This control determines the maximum range of the
UM1 before audio signal dropout. Although it can be adjusted using the supplied
plastic screwdriver, it should normally be left at its factory setting. See the Setting Up
and Using the AirLine System section on page 14 in this manual for more information.
7 |
ACEC
