Guided Tour
10 1112 13 14
PHONES
LR
LOUDNESSVOLUMEBATTERY BALANCE
ENGLISH
12: Volume control- Used to set the level of the signal in connected
earbuds.
13: Battery LED- This LED lights red when battery level is low and the
battery needs to be replaced.
14: Balance control- Adjusts the relative levels of the two signals
arriving at the EarAmp stereo input (see #2 on page 4). When set at the
center 12 oOclock position, both signals are presented to connected
earbuds at equal strength. When the EarAmpa is operating in OStereo�
mode (that is, when the 2 CH/Stereo switch [see #6 on page 5] is set to
OStereo,�) turning the balance control clockwise increases the relative
amount of right channel signal (that is, the signal in your right ear) and
turning it counterclockwise increases the relative amount of left channel
signal (that is, the signal in your left ear). When the EarAmpa is
operating in O2 CH� mode (that is, when the 2 CH/Stereo switch [see #6
on page 5] is set to O2 CH,�) both channels are internally mixed to mono
and routed to both earbuds. In 2 CH mode, turning the balance control
clockwise increases the relative amount of right channel signal (though it
will be heard in both ears) and turning it counterclockwise increases the
relative amount of left channel signal (again, heard in both ears).
15: Belt clip- Use this to clip the EarAmpa to your belt for convenient
operation.
15
7 |