Adjustment tips for the operating menu
Switching between channel banks
BANKVia the Bank menu, you can switch between the nine channel banks of the
Bankew 300 IEM G2 transmitter and receiver. The channel banks 1 to 8 have
up to 12 switchable channels that are factory-preset to a transmission/
receiving frequency (see The channel bank system on page 42). The
channel bank U (user bank) also has up to 12 switchable channels to store
your selection out of 1440 transmission/receiving frequencies that are freely
selectable within the preset frequency range.
When switching from one channel bank to another, the channel with the
lowest channel number is automatically displayed. If, during the last scan of
this channel bank, an interfering frequency was detected on the channel with
the lowest channel number, the receiver display panel automatically displays
the next free channel (see below).
Switching between the channels in a channel bank
CHANVia the ŤChannel menu, you can switch between the channels in a channel
Channelbank.
Always set the transmitter and the receiver of a transmission link to the same
channel. After scanning a channel bank (see Scanning the channel banks for
free channels (receiver only) on page 62), only the free channels are
displayed. Set the transmitter to one of the free channels
Selecting the frequencies to be stored
in the channel bank U
TUNEVia the Tune menu, you can select the frequencies to be stored in the
channel bank U (user bank).
Tune
When you have selected one of the channel banks 1 to 8 and then select
the Tune menu, the transmitter or receiver automatically switches to
channel 01 of the channel bank U. In this case, U.01 briefly appears on
the display.
Use the / buttons to select the desired transmission or receiving
frequency. Transmission and receiving frequencies are tunable in 25-kHz
steps within a switching bandwidth of 36 MHz max. For intermodulation-
free frequencies, please refer to the enclosed frequency table.
Scanning the channel banks for free channels
(receiver only)
SCANBefore putting one or several transmission links into operation, you should
scan the selected channel bank for free channels.
62 |