Supplied parts /
OPERATION MANUAL
GEBRAUCHSANLEITUNG
MODE DOEMPLOI
MANUAL DE MANEJO
MAIN UNIT WALL BRACKET
Wall bracket x 1Main unit bracket x 1
WANDHALTERUNG F?R HAUPTGER?T
SUPPORT MURAL POUR UNIT? PRINCIPALE
SOPORTE DE PARED UNIDAD CENTRAL
MODELMODELL
Screw
MODéLE
(3 mm in diameter x 12 mm) x 2
MODELO
(3/32� x 1/2�)
(4 mm in diameter x 8 mm) x 2
AD-AS10WA(1/8� x 3/8�)
Pattern paper x 1Operation manual x 1
ENGLISH /
Thank you for purchasing this SHARP product.
To obtain the best performance from this product, please read this manual carefully.
It will guide you in operating your SHARP product.
Prepare for mounting /
Screws to mount the wall bracket on the wall are not supplied. Purchase by yourself
according to the material of the wall.
Precautions /
Warning
Screw (commercially available) x 64-5 mm
Install brackets properly by following the operation manual.Consult your dealer or installer about the type.(1/8"- 1/4")
5-6 mm (1/4")
Improper installation may cause the main unit to fall leading to injury or damage6
to the unit.
To ensure a proper installation, contact your dealer or installer.
During installation, be careful not to pinch your fingers.40-50 mm9-13 mm
The wall should be strong enough to support the weight of the main unit.(1-5/8"- 2")(3/8"- 1/2")
(Install into a reinforced area of the wall, e.g., stud.)
Do not put any extra load on the wall brackets. It may cause the main unit to fall
leading to injury or damage to the unit.Dowel (commercially available) x 6 (For concrete walls)
Do not modify or change the brackets. It may cause the main unit to fall leadingConsult your dealer or installer about the type.
to injury or damage to the unit.6
Caution
This main unit wall bracket is designed exclusively for SHARPOs SD-AS10Adhesive tape
(SD-AS10H/SD-AS10W). Use with other products may result in instabilityCushions or soft cloths
Tools (including Phillips screwdriver)
causing injury.
Do not block the ventilation openings of the main unit with anything as this can
cause excessive heat buildup leading to damage to the unit.
Carefully select a mounting position so the unit does not cause any bodily injury.
Never step on or hang from the wall mount bracket as this may cause injury or
damage to the unit. Pay especially close attention to children.
Check the wall strength. SHARP is not liable for accidents caused by insuf-Mounting on a wooden wall
Mount on a sturdy part with thickness5 cm (2") or more
ficient strength of the wall or improper mounting.
of 5 cm (2�) or more.
Improper installation may cause the main unit to fall.
Do not mount on a thin wall (plywood)
If you need assistance in installation, contact your dealer or installer.
or plaster board.
5-6 mm (1/4")
Mounting on a concrete wall
Drill holes in the wall and hammer dowels (commercially available) into them.
Drive screws (commercially available) into the dowels.
Hammer in dowels until the open ends are even with the wall.
50-60 mm (2� - 2-3/8�)
8-10 mm (3/8�)
DowelScrew
(commercially available)(commercially available)
Printed in Malaysia
Geduckt in Malaysia
TINSZA122AWZZ
ImprimŽ en Malaisie
04K R YT 1Impreso en Malaysia |
ACEC
