MOVING INSTRUCTIONS
When moving this copier, follow the procedure below.
When moving this copier, be sure to remove the TD cartridge in advance.
Turn the power switch off and disconnect the power
1cord.
Open the bypass tray. Lift slightly on the side cover
2and slide the cover out until it stops. Push gently on
both sides of the front cover and open it.
Lift the TD cartridge lock release lever and pull the
TD cartridge lock 3cartridge out until the green strap handle can be grasped
release leverby the right hand. Lift the cartridge by the handle while
supporting it with the left hand at the green label position
to remove it.
Close the front cover by pushing both sides with your
4hands and then close the side cover by pressing the
handle on the cover.
When closing the covers, be sure to close the front
cover securely and then close the side cover. If the
covers are closed in the wrong order, the covers may
be damaged.
Gently lift and pull out the paper tray until it stops.
GENERAL INFORMATION5
Push the centre of the pressure plate down until it locks
6in place and lock the plate using the pressure plate lock
which has been stored in the front of the paper tray.
Use a coin (or suitable object) to attach to the left side
7of the copier the screw that has been stored in the front
of the paper tray (upper paper tray in AL-1622).
When shipping the copier, the screw must be reinstalled
to prevent shipping damage.
Moving instructions
Push the paper tray back into the copier.
8For AL-1622, repeat steps 5, 6, and 8 for both the upper and lower
trays.
Close the bypass tray. Attach the packing materials and
9tape which were removed during installation of the
copier. See page 11, SET-UP.
Pack the copier into the carton. See page 10, CHECKING
10PACKED COMPONENTS AND ACCESSORIES.
61 |
ACEC
