ApollonII_fax_ex.book 5 Mo+ 9Ţ9�9�9a9a?9Ţ9�a???a?
?�9�(9Ţ9a 1
KEY OPERATOR PROGRAMS
Initial resolution settingAuto wake up print
This setting is used to change the defaultUse this setting to select how the machine
resolution setting for fax mode from "STANDARD"responds if a fax is received when the machine
to "FINE", "SUPER FINE", or "ULTRA FINE".power switch is turned off (the fax power switch is
"HALF TONE" can also be selected for the latterturned on).
three resolution settings. "STANDARD" is normallyAuto wake up print is normally turned on, which
selected for the initial resolution setting. If you wishmeans that the machine automatically activates
to select "HALF TONE" for the selected resolutionand prints the received fax. If you turn off this
setting, touch the [HALF TONE] key to highlight it.setting, received faxes will not be printed until the
machine power switch is turned on.
NOTES
"HALF TONE" cannot be selected for
Pause time setting
"STANDARD" resolution.
This setting is used to select the duration of pauses
For more information on each of the resolutionthat are inserted in destination fax numbers.
settings, refer to page 1-9.Normally the setting is 2 seconds, which means
that each time the [PAUSE] key is touched when
Own number and name setdialing or storing a fax number, a pause of 2
Use this setting to enter the fax number of theseconds is inserted.
machine and the name of the user. The enteredThe pause time can be set to any number of
seconds from 1 to 15.
name and number are printed at the top of each fax
page you send. The number is also used as a
Original print on transaction report
passcode when performing polling reception (see
This program is used to have part of the first page
"USING THE POLLING FUNCTION" on page 3-6).
of the fax printed on the transaction report . This
You can check your entries by printing out the
program is used in conjunction with the transaction
Sender List. Refer to page 8-12.
report print select setting (next page), and is not
effective when printing of the transaction report is
Touch the [NAME] key and enter the name.
1disabled.
The name entry screen appears.
This program is normally configured so that part of
Up to 20 characters can be entered for the name.
the fax is printed on the transaction report when a
Refer to page 6-15 for the procedure for enteringtransmission is not successful.
characters.
Speaker volume setting
Touch the [FAX No.] key and enter the fax
2This program is used to adjust the volume of the six
number.
following sounds that are emitted from the speaker:
Enter up to 20 digits for the number using the1.speaker, 2. ringer volume, 3. line monitor, 4. fax
numeric keys.
receive signal, 5. Fax communication error signal,
To enter a "+", press the "" key.6. scan complete sound.
To enter a hyphen, touch the [PAUSE] key. To
KEY OPERATOR PROGRAMS
enter a space, touch the [SPACE] key.
VOLUME ADJUSTMENTOK
If you make a mistake, press the [C] key and
SPEAKER
re-enter the correct digit.
8
RINGER VOLUME
NOTE
LINE MONITOR
If a hyphen is entered, it will be changed to a space
at the time of transmission.
Volume:Low Volume:Medium Volume:High Off
Touch the [OK] key.
To change the volume, touch the desired volume
3
You will return to the OWN NUMBER AND NAMEkey. Factory default setting varies with
SET screen. The number you entered appears.destinations.
Make sure it is correct.
8-5 |
ACEC
