Pegasus-E_Copy_Ex.book 83 Mo+ 9Ţ9�9�9a9a?9Ţ9�a?�?a?
? e9�9�(9a9� 1
KEY OPERATOR'S GUIDE
Select "AUTO CLEAR" and press the [OK] key. The
System requirements for USB 2.0 following screen will appear.
(Hi-Speed mode)
AUTO CLEAR
The USB port (USB-2) on the machine supports
USB 2.0 Hi-Speed mode.
60 sec.
The following system is required to use USB 2.0
(Hi-Speed mode): (0~120)
The computer is running Windows XP/2000 and the
Microsoft USB 2.0 driver is pre-installed, or the
USB 2.0 driver for Windows XP/2000 that Microsoft
Select the desired time with the [ ] or [ ]
provides through Windows Update is installed.1
* Even when the Microsoft USB 2.0 driver is installed, key.
some USB 2.0 expansion cards are not capable of If you do not want auto clear to operate, select "0".
attaining the speed stipulated by the Hi-Speed
standard. This problem can often be fixed by installing Press the [OK] key.
2
a more recent driver for the card. To obtain the most
recent driver for your card, contact the card's
manufacturer.
DISABLE DISPLAY TIMEOUT
This program is used to select whether or not the
RETURN FROM COPY MODE TIMING
display will automatically return to the base screen if
When there are print jobs or fax print jobs waiting to be no keys are pressed on the operation panel for one
printed after copy job is finished, this program is used minute in scan or fax mode.
to set a brief wait time until printing of those jobs The factory default setting is automatic return to the
begins. Setting a brief wait time allows another copy base screen.
job to be performed following the previous copy job.
Time selections are "0 sec.", "10 sec.", "30 sec.", and To disable automatic return to the base screen, select
"60 sec."."DISABLE DISPLAY TIMEOUT", and press the [OK]
The factory default setting is 30 seconds.key so that a checkmark appears in the checkbox.
Select "RETURN FROM COPY MODE TIMING" and To re-enable automatic return to the base screen,
press the [OK] key. The following screen will appear.select "DISABLE DISPLAY TIMEOUT" once again
and press the [OK] key to clear the checkmark
RETURN FROM COPY
from the checkbox.
30 sec.
(0~60)
LANGUAGE SETTING
This program is used to select the display language.
Select "LANGUAGE SETTING", press the [OK] key,
Select the desired time with the [ ] or [ ] and follow the steps below.
1
key.
Select the display language with the [ ] or 7
1
Press the [OK] key.[ ] key.
2
Press the [OK] key.
2
OPERATION SETTING
These programs are used to configure various settings MESSAGE TIME
related to the operation panel. To access one of these
This program is used to set the length of time that
programs, select "OPERATION SETTING" in the
messages appear in the display (this applies to
mode selection screen, select the desired program in
messages that appear for a certain length of time and
the operation setting screen, and press the [OK] key.
then automatically disappear.) Select from "SHORT (3
sec.)", "NORMAL (6 sec.)", or "LONG (9 sec.)".
AUTO CLEAR
The factory default setting is "NORMAL (6 sec.)".
This function returns the copy settings to the default
settings if the operation panel is not used for the
duration of time set with this program following the end
of a copy job. Time selections are "0 sec.", "10 sec.",
"20 sec.", "60 sec.", "90 sec." and "120 sec.".
The factory default setting is 60 seconds.
83 |
ACEC
