HOW TO USE THE BUILT-IN TIMER
Timer playback
The unit will turn on and play the selected source at the pre-
set time.
Before setting the timer, make sure that the clock setting
is correct (page 10).
(Main unit operation)
TUNER/(BAND)MEMORY/SET
ON/
STAND-BY
TIMER/
SLEEP
CDVOLUME
TAPE
(1 2)
VIDEO
/AUX
TUNING/
TIME
()
1Press the ON/STAND-BY button to turn the power5Press the TUNING/TIME ( or ) button to set the
on.minute start time, then press the MEMORY/SET but-
ton.
2Press the CD, TUNER (BAND), TAPE (1 2) or
VIDEO/AUX button to select the desired function,
and then adjust the sound volume using the VOL-
UME buttons.
3Press the TIMER/SLEEP button repeatedly until a
white " " is displayed.
The unit will enter the stand-by mode automatically, and
the timer set indicator will light up.
The timer set indicator will flash.
6When the preset time is reached, the timer playback
will start.
The volume will increase gradually.
7If you select CD or TAPE, the unit will enter the
stand-by mode after the playback. If you select
4Press the TUNING/TIME ( or ) button to set the
TUNER or VIDEO/AUX, it will enter the stand-by
hour start time, then press the MEMORY/SET but-mode one hour after the timer playback starts.
ton.
To cancel timer operation:
Press the ON/STAND-BY button to turn the power on.
To change the programmed contents:
Start again from step 1.
Notes:
When performing timer playback using an external unit
connected to the VIDEO/AUX sockets, only the power of
the main unit will enter the stand-by mode automatically.
(The power of the external unit will not be turned off.)
Once the time is set, the setting will be retained until a
new time is entered.
30 |
ACEC
