CD-DP900S
Listening to a cassette tape (TAPE 1 or TAPE 2)
Before playback:Playback is possible in TAPE 1 compartment as well as in TAPE 2.
!For playback, use normal or low-noise tapes for the best sound.
(Metal or CrO tapes are not recommended.)1Press the ON/STAND-BY button to turn the power on.
!Do not use C-120 tapes or poor-quality tapes, as they may cause mal-
functions.2Open the cassette door by pushing the area marked " PUSH EJECT".
!Before loading a tape into the cassette compartment, tighten the slack
with a pen or a pencil.
3Load a cassette into the TAPE 1 or TAPE 2
cassette compartment with the side to be
played facing toward you.6
TAPE 1TAPE 2
4Press the TAPE (1 2) button to select the cassette you want to
listen to.
5Press the / button to start playback.
When playback is performed using the remote control, press the TAPTape PlaybackE 1 or
TAPE 2 button.
To stop playback:
Press the (TAPE ) button.
Fast forward/rewind: (TAPE 2 only)
- Listening to a cassette tape (TAPE 1 or TAPE 2) -
1 Press the (TAPE ) button, then press the TAPE (1 2) button to select TAPE 2.
2 To advance the tape, press the / ( ) button. To rewind it, press the /
( ) button.
Caution:
!To remove the cassette, press the (TAPE ) button, and then open the compart-
ment.
!Before changing from one tape operation to another, press the (TAPE ) button.
!If a power failure occurs during tape operation, the tape head will remain engaged
with the tape and the cassette door will not open. In this case, wait until the power
is restored.
Sound control (See page 14.)21
03/11/28 CD-DP900S(E)2.fmTINSEA032AWZZ |
ACEC
