CD-G10000DVD
Precautions
CP-G10000
ENGLISH
HGeneralWarning:
The voltage used must be the same as that specified on this unit.
I Please ensure that the equipment is positioned in a well ventilated area
Using this product with a higher voltage other than that which is specified is
and ensure that there is at least 10 cm (4") of free space along the sides,
top and back of the equipment.dangerous and may result in a fire or other type of accident causing damage.
SHARP will not be held responsible for any damage resulting from use of this
10 cm (4") 10 cm (4")unit with a voltage other than that which is specified.
10 cm (4")
HVolume control
The sound level at a given volume setting depends on speaker efficiency,
location and various other factors. It is advisable to avoid exposure to high
10 cm (4")volume levels. Do not turn the volume on to full at switch on and listen to musicFloorTable
at moderate levels.
I Do not place active subwoofer system on the same surface as mainHCare of DVD/Video CD/CD discs
unit to prevent sound interruption during playback.DVD/Video CD/CD discs are fairly resistant to damage, however mistracking
I Use the unit on a firm, level surface free from vibration.can occur due to an accumulation of dirt on the disc surface. Follow the
I Keep the unit away from direct sunlight, strong magnetic fields, excessiveguidelines below for maximum enjoyment from your DVD/Video CD/CD
dust, humidity and electronic/electrical equipment (home computers,collection and player.
facsimiles, etc.) which generate electrical noise.
I Do not write on either side of the disc, particularly the non-label side from
I Do not place anything on top of the unit.which signals are read. Do not mark this surface.
I Do not expose the unit to moisture, to temperatures higher than 60!C (140!F)
I Keep your discs away from direct sunlight, heat, and excessive moisture.
or to extremely low temperatures.
I If your system does not work properly, disconnect the AC power lead fromI Always hold the DVD/Video CD/CDs by the edges. Fingerprints, dirt, or
water on the DVD/Video CD/CDs can cause noise or mistracking. If a DVD/
the wall socket. Plug the AC power lead back in, and then turn on your
Video CD/CD is dirty or does not play properly, clean it with a soft, dry
system.cloth, wiping straight out from the centre, along the radius.
I In case of an electrical storm, unplug the unit for safety.
General InformationI Hold the AC power plug by the head when removing it from the wall socket,
as pulling the lead can damage internal wires.
NOYES
I Do not remove the outer cover, as this may result in electric shock.
Refer internal service to your local SHARP service facility.Correct
I The ventilation should not be impeded by covering the ventilation openings
with items, such as newspapers, tablecloths, curtains, etc.
I No naked flame sources, such as lighted candles, should be placed on the
apparatus.
I Attention should be drawn to the environmental aspects of battery disposal.
I This unit should only be used within the range of 5!C - 35!C (41!F- 95!F).
E-3
*CD-G10000DVD(EN)02-05305.1.17, 10:46
CD-G10000DVD (S)
TINSZA160AWZZ |
ACEC
