Basic Connection
1Connect the TV aerial
Connection Using Aerial Cables and SCARTcable to the ANTENNA IN
Cablesjack on the rear of this
Recorder.
The following connection is the basic connection to watch or record TV
programmes.2Connect the ANTENNA
OUT jack on the rear of
Important!this Recorder to the
Y Be sure to turn off and unplug from the AC outlet this Recorder and allantenna input jack on your
equipment before connecting the cables.TV using the supplied
Y Read through the operation manual for the equipment to be connected.coaxial cable.
NOTE3Connect the LINE 1(TV)
Y To connect using S-video or compo-jack on the rear of this
nent cables, see OUsing Other TypesRecorder to the SCART
of Video Output� on page 24.input jack on your TV
Aerial cableusing the SCART cable
1(commercially available)(commercially available).
To ANTENNA
IN jack
The RecorderWhen connecting with your
external receiver
4Connect the LINE 2(DE-
CODER/EXT) jack on the
rear of this Recorder to the
SCART output jack on your
To ANTENNA
external receiver using the
OUT jackSCART cable.
66
To LINE 1(TV)5Connect the G-LINK jack
SCARTon the rear of this
To LINE 2
SCARTRecorder with the external
receiver using G-LINK
234
Coaxial cable SCART cableSCART cableG-LINK cable (supplied). Fix the
(supplied)(commercially(commerciallycableinfrared transmitter of the
available) available)(supplied)
G-LINK cable as described
below left. (See page 46)
To SCART
To SCARTY If you use DVB-T (Digital Video
inputoutputBroadcasting Terrestrial),
To antenna
connect the TV aerial cable to
input jackthe DVB-T and the DVB-T to
the ANTENNA IN jack of the
Recorder (see 6 in the chart)
instead of the connection in
the Step 1 above (see 1 in the
chart).
The external receiver
TV NOTE
(satellite system,
Y Even when you use an external
cable TV set-top box
Infrared Transmitterreceiver, you must connect the
or DVB-T(Digital Recorder to Aerial via ANTENNA IN
Video Broadcasting jack.
Terrestrial))
Fix the Infrared Transmitter in
front of the infrared receptor.
Y According to the input signal from
Important!the external equipment to L2, you
When connecting to your TV using SCART cable:must select the type of video signal
Y When playing back HDD/DVD, the recorder side input is selected(S-VIDEO or RGB/COMPOSITE) in
automatically. When the channel is changed at the TV side under thisOL2� setting. This can be done in
setting, the selection is normally changed to the reception channel, butOOTHER SETTINGS� � OADJUST-
it may not be changed for certain TV models. If this happens, press theMENT� � OVIDEO/AUDIO SETTING�
TV/DVD button on the remote control.� OCONNECTING TERMINAL�.
Y Progressive output works only when the Recorder is connected with TV by
Component video cable.
23
HR480H-023-026232005.3.23, 4:58 PM |
ACEC
