Auto Installation(INSTALLATION AUTO)
Turning the Power OnAbout the Power Supply
Y Do not unplug the power cord immedi-
Press OPERATE on the remoteately after you plug it into the AC outlet
control or Recorder to turn on the(less than about 15 seconds after
power of Recorder.plugging in). In very rare cases, this
may cause the memory to revert to its
Y When you turn on power, the HDD mode
initial state, and all timer programmes
indicator and DVD mode indicator in the
will be erased. If you pull out the power
Front Panel Display will blink. As the
plug while power is on, it will take a
system processing is in progress during
while for the hard disc to get ready
blinking, wait until the blinking stops and
when you turn on power the next time.
the HDD mode indicator turns on.
During this time you can only view live
Y When the Recorder power is turned on for the
broadcasts.
first time after purchase, the OAUTO
Y If you turn on power in a low tempera-
INSTALLATION� screen is displayed. Followture environment, only live broadcast
the procedure shown on pages 25, 26.viewing is possible until the hard disc
NOTE(HDD) reaches its operating tempera-
ture.Operating the power source while TV
listings data is being downloaded
Y Even when the power is off, during
download of TV listings data, the internalUsing the INSTALLATION
state of the power source is on. When you
want to use the Recorder while TV listingsAUTO
data is being downloaded, press OPER-
for Initial Setting
ATE to cause the STANDBY indicator of the
Recorder to be lit red. (It may take 1-2
minutes for the STANDBY indicator to be litWhen the Recorder power is turned on for the
red.) After the STANDBY indicator is lit red,first time after purchase, the OINSTALLATION
press OPERATE button once more. (TheAUTO(AUTO INSTALLATION)� screen is
download of TV listings data will bedisplayed. You can use the OINSTALLATION
suspended.)AUTO(AUTO INSTALLATION)� function for
Y When TV listings data is being down-easy initial settings regarding On-Screen
loaded, the Front Panel Display appears asDisplay language, TV channel, etc. From the
follows:second time on, the OAUTO INSTALLATION�
screen will not appear.
Preparation
Y Turn on the power of TV and switch to the
AV input used to connect to the Recorder.
1Press OPERATE for the first time
To Turn the Power Offafter purchase.
INSTALLATION AUTO24/12[SAT]10:28
Press OPERATE on the remote
control or Recorder to turn off power.INSTALLATION AUTO
L'INSTALLATION AUTO D?MARRE AUTOMATIQUEMENT:
Y The HDD mode indicator and DVD modeAPPUYER SUR LA TOUCHE ENTER
indicator will go out, and the STANDBY
indicator will light up.
Y If you press OPERATE again immediately
ENTRERafter turning off, the Recorder may not turn
on. If this happens, wait a while and then
turn on power again.ENTERENTER
Y The OINSTALLATION AUTO(AUTO
INSTALLATION)� screen is displayed.
2Press SET/ENTER to continue
with the installation.
INSTALLATION AUTO [LANGUE]24/12[SAT]10:28
S?LECTIONNER LA LANGUE D'AFFICHAGE.
ENGLISHESPA?OL
DEUTSCHSVENSKA
FRAN?AISNEDERLANDS
ITALIANO
Y The OLANGUE(LANGUAGE)� screen
is displayed.
Continued on Next Page |||
25 GB
HR480F_GB-023-0262505.3.23, 1:45 PM |
ACEC
