Major Components
Setting the Remote Con-
Setting the Remote
trol Code of the Recorder
Control Code
Y Two types of remote control codes operate3Press OPERATE to turn off the
this Recorder: RC-1 and RC-2. If youRecorder.
operate this Recorder by remote control
4Press and hold CHANNEL " and
along with another SHARP DVD recorder or
CHANNEL ' on the Recorder
DVD player placed next to it simulta-together for more than 5 seconds.
neously, switching the remote control code
Y Each time this operation is performed,
(both the Recorder and remote control) tothe code of the Recorder toggles
one of the signals (RC-1 or RC-2) will letbetween ORC-1� and ORC-2�. The front
you operate only with this Recorder.panel display changes as the code
Y Make sure to set the Recorder and remotechanges.
control to the same remote code. You canY Press OPERATE on the remote
not operate the Recorder if they are not setcontrol to see if you can turn on/off
the Recorder.
to the same code.
If remote control does not
Setting the Remote Con-
work
trol Code of the RemotePress OPERATE on the remote control and
Example: Setting the code to ORC-2�.check the front panel display (RC-1 or RC-2).
Set the remote control code according to the
1Press and hold OPERATE and 2display and press OPERATE to see if you
together for more than 5 seconds.can turn on/off the Recorder.
2Press OPERATE of this Recorder
to see if you can turn it on/off.
Y If you cannot, go to step 3.
Y To change the setting back to ORC-1�,
press and hold OPERATE and 1 in
the step 1 above.
Front Panel
Display
GB 22
HR480F_GB-015-0222205.3.23, 1:44 PM |
ACEC
