Getting StartedGetting Started
UnpackingHooking Up the System
Check that you received the following items:
Y Audio cord (1)Overview
Y Video cord (1)
This section describes how to hook up the CD player to
Y Monaural (2P) mini-plug cord (1) (Connecting cord
an amplifier. Be sure to turn off the power of each
for CONTROL A1 ) (supplied for Canadian models
component before making the connections.
only)
Y Remote commander (remote) (1)
DIGITAL OUT
Y Size AA (LR6) batteries (3)(OPTICAL)
CONTROL A1MONITOR OUT
CD player
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert three size AA (LR6) batteries (supplied) by
matching the + and � ends on the batteries to the
diagram inside the battery compartment.
Insert the negative (�) end first, then push in and down
until the positive (+) end clicks into position.
To an AC outlet
When using the remote, point it at the remote sensor
on the player.To line output (L)To line output (R)
To audio inputAmplifier
zWhen to replace batteries
If E flashes in the remoteOs display, replace all the
batteries with new alkaline batteries. Use of battery types
other than alkaline batteries, such as manganese: Signal flowTo an AC outlet
batteries, may not last longer than the alkaline batteries.
The loaded memory in the remote will be retained for a
few minutes while you replace the batteries.
What cords will I need?
Audio cord (supplied) (1)
Notes
WhiteWhite
Y Do not leave the remote near an extremely hot or humid
(L)(L)
place.
RedRed
Y Do not drop any foreign object into the remote casing,
(R)(R)
particularly when replacing the batteries.
Y Do not expose the remote sensor to direct sunlight or leave
too near lighting apparatuses. Doing so may cause a
malfunction.
Y If you do not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
4 |
ACEC
