This manual describes how to operate this unit by using the remote control transmitter.
To operate this unit on the front panel, use the corresponding buttons on the front panel.
BASIC OPERATION
SYNCHRODIMMERTIMECLOSEOPEN/
SPACEPEAKTAPECLEARPROG2, 3
POWER123INDEX
1456+I0
7890
AUTOREPEAT RANDOM
DISPLAY OFF
SEARCH
�+OUTPUT LEVELSKIP
STOPPAUSEPLAY
4
1 Turn the power on.3 Close the disc tray.
POWER
OPEN/
CLOSE
2 Load a disc.Label side
upward
4
OPEN/PLAY
CLOSE
Play will begin from the first track of the disc.
Disc tray
Display information at disc playNotes
YAfter closing the disc tray by pressing the OPEN/CLOSE
A��button, the display shows the total number of tracks and the
total recorded time of the disc for a few seconds.
SINGLE
TOTAL
3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
YAdditionally, you can close the disc tray by pressing the
A
PLAY (PLAY/PAUSE ) button, a numeric button or the
AShows the track number selected or being played.RANDOM button, or by pressing the front edge of the disc
�Shows the time displays. (Refer to OSelecting timetray gently. If the tray is closed in these ways, play will begin
displays� on page 10.)
automatically, however, the display will not show the total
�CDX-590 and CDX-490 onlynumber of tracks and the total recorded time of the disc.
Shows the level of signals output into an amplifier or the
headphone level adjusted by using the OUTPUT LEVEL
button.
ADisplays the numbers that correspond to the numbers of
tracks (as high as number 20) on the disc. After each
track is played, its corresponding number disappears so
the number of remaining tracks (and their numbers) can
be seen at a glance.
To turn off the power
Press the POWER switch again.
8 |
ACEC
