Attaching the front panel
Place the hole a in the front panel onto the
spindle b on the unit as illustrated, then push
Getting Started
the left side in.
a
Resetting the unit
Before operating the unit for the first time orb
after replacing the car battery, you must reset
the unit.
Remove the front panel and press the reset
button with a pointed object, such as a
ballpoint pen.
Reset button
Notes
?
YPressing the reset button will erase the clock
setting and some memorised functions.
YWhen you connect the power supply cord to the
unit or reset the unit, wait for about 10 seconds
before you insert a disc. If you insert a disc within
these 10 seconds, the unit will not be reset, and
you will have to press the reset button again.
Detaching the front panel
Notes
You can detach the front panel of this unit toYBe sure not to attach the front panel upside
protect the unit from being stolen.down.
YDo not press the front panel too hard against the
unit when attaching it.
Before detaching the front panel, be sureYDo not press too hard or put excessive pressure
to press (OFF). Press (OPEN), then slideon the display window of the front panel.
the front panel to the right side, and pullYDo not expose the front panel to direct sunlight
out the left side.or heat sources such as hot air ducts, and do not
leave it in a humid place. Never leave it on the
dashboard of a car parked in direct sunlight or
where there may be a considerable rise in
temperature.
Caution alarm
1
If you turn the ignition key switch to the OFF
position without removing the front panel, the
2
caution alarm will beep for a few seconds.
If you connect an optional power amplifier
Notesand do not use the built-in amplifier, the beep
YBe sure not to drop the panel when detaching itsound will be deactivated.
from the unit.
YIf you detach the panel while the unit is still
turned on, the power will turn off automatically
to prevent the speakers from being damaged.
YWhen carrying the front panel with you, use the
supplied front panel case.
6 |
ACEC
