Detaching the front panel
Getting Started
You can detach the front panel of this unit to
protect the unit from being stolen.
Resetting the unitCaution alarm
If you turn the ignition switch to the OFF
Before operating the unit for the first time, or position without removing the front panel, the
after replacing the car battery or changing the
caution alarm will beep for a few seconds.
connections, you must reset the unit.If you connect an optional amplifier and do not
Remove the front panel and press the RESET
use the built-in amplifier, the beep sound will be
button with a pointed object, such as a ballpoint deactivated.
pen.
1Press (OFF)*.
CD/MD playback or radio reception stops
(the key illumination and display remain on).
* If your car has no ACC position on the ignition
switch, be sure to turn the unit off by pressing
(OFF) until the display disappears to avoid car
RESET buttonbattery drain.
Note2Press (OPEN), then slide the front
Pressing the RESET button will erase the clock sepatnetinlg t o the right, and gently pull out
and some stored contents.the left end of the front panel.
1
2
Notes
If you detach the panel while the unit is still turned
on, the power will turn off automatically to prevent
the speakers from being damaged.
Do not drop or put excessive pressure on the front
panel and its display window.
Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
Tip
When carrying the front panel with you, use the
supplied front panel case.
continue to next patge
7 |
ACEC
