WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.
This appliance is
classified as a CLASS 1
LASER product.
The CLASS 1 LASER
PRODUCT MARKING
is located on the rear
exterior.
The following caution label is located inside the unit.
IN NO EVENT SHALL SELLER BE LIABLE FOR ANY DIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE
PRODUCT OR THE USE OF ANY PRODUCT.
NOTICE FOR THE CUSTOMERS INinterference to radio communications. However, there
is no guarantee that interference will not occur in a
THE U.S.A.
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
� Reorient or relocate the receiving antenna.
� Increase the separation between the equipment and
receiver.
� Connect the equipment into an outlet on a circuit
different from that to which the receiver is
This symbol is intended to alert theconnected.
user to the presence of uninsulated
Odangerous voltage� within the� Consult the dealer or an experienced radio/TV
productOs enclosure that may be oftechnician for help.
sufficient magnitude to constitute aCAUTION
risk of electric shock to persons.You are cautioned that any changes or modifications
This symbol is intended to alert thenot expressly approved in this manual could void
user to the presence of importantyour authority to operate this equipment.
operating and maintenance
NOTICE FOR THE CUSTOMERS IN
(servicing) instructions in theCANADA
literature accompanying the
appliance.CAUTION
CAUTIONTO PREVENT ELECTRIC SHOCK, DO NOT USE
The use of optical instruments with this product willTHIS POLARIZED AC PLUG WITH AN
increase eye hazard.EXTENSION CORD, RECEPTACLE OR OTHER
INFORMATIONOUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuantThis system is equipped with the Dolby* B-type noise
to Part 15 of the FCC Rules. These limits arereduction system.
designed to provide reasonable protection against* Dolby noise reduction manufactured under license
harmful interference in a residential installation. Thisfrom Dolby Laboratories Licensing Corporation.
equipment generates, uses, and can radiate radioODOLBY� and the double-D symbol ; are
2frequency energy and, if not installed and used intrademarks of Dolby Laboratories Licensing
accordance with the instructions, may cause harmfulCorporation. |
ACEC
