Manual tuning preset
Listening to the radio
You can manually tune in and store the radio
frequency of the desired stations.You can listen to a radio station either by
selecting a preset station, or by manually tuning
1Press TUNER BAND repeatedly to
in the station.
select FM or AM.
2Press TUNING +/- repeatedly to tune in
Listening to a preset stationTuner
the desired station.
3Press TUNER MEMORY.? Preset Tuning
The preset number appears. Station storage
Preset radio stations in the tuner?s memory first
starts with preset number 1. If preset
(see ?Presetting radio stations? on page 8).
stations have been erased, then stations are
stored to the lowest preset number1 Press TUNER BAND.
containing no station.
2Press PRESET +/- repeatedly to select
4Repeat steps 1 through 3 to preset the desired preset station (or RDS
other stations.station name*).
* European model only
Other Operations
ToDo this
Listening to non-preset radio
Tune in a statFolionl ow the procedure described
with a weak siignn ?alManual tuning preset? station
(page 9).
? Manual Tuning
Erase a preset Select the preset number of the
stationstation to be erased, and then
1Press TUNER BAND repeatedly to
press CLEAR twice.
select FM or AM.
2Press TUNING +/- repeatedly to tune in
To change the AM tuning interval
the desired station.
(except for European and Middle
Tips
Eastern models)
To improve broadcast reception, adjust the supplied
The AM tuning interval is factory-preset to 9
antennas, or connect a commercially available
kHz (or 10 kHz for some areas). To chextanegren talh ae ntenna.
AM tuning interval, tune in any AM staWtiohen ann fir FMs ts.tere o program has static noise, press
While holding TUNER BAND, p?/1r. ess REPEAT/FM MODE until ?MONO? appears. There
When you change the interval, all thew AillM /beFM n o stereo effect, but the reception will
preset stations are erased. To reset timprhe iove.nterval,
tune in any AM station first. While hIon slditnepg 2, press and hold TUNING +/- until the
TUNER BAND, pres?/s1 .frequency indication starts to change. Scanning stops
when the system tunes in a station (Automatic
TipsTuning).
The preset stations are retained for half a day even if
To record the radio programs, use manual recording
you disconnect the power cord or if a power failure
(page 12).
occurs.
You can change the display into the clock display
To improve the reception, adjust the supplied
(for the six seconds) by pressing DISPLAY.
antennas or connect an external antenna.
GB
9 |
ACEC
