Additional Information
On placement
YPlace the system in a location with adequate air
Precautionscirculation, and do not place anything on top of the
system.
The nameplate is located on the bottomYDo not place the system in an inclined position.
exterior.YDo not place the system in locations where it is:
N Extremely hot or cold
On safety
N Dusty or dirty
YThe glass over the display window on the cover isN Very humid
made of tempered glass.N Subject to vibrations
Under normal conditions, this tempered glass is
N Subject to direct sunlight.
more shock resistant and able to bear more weight
than ordinary glass. This glass, however, mayOn heat build up
shatter if it receives a sharp blow or if it is
N Although the system heats up during operation,
scratched.this is not a malfunction.
YThe system is not disconnected from the AC powerN Place the system in a location with adequate
source (mains) as long as it is connected to the wallventilation to prevent heat build up in the system.
outlet, even if the system itself has been turned off.
If you continuously use this system at a large volume,Timer/Optional Components/Additional Information
YUnplug the system from the wall outlet if it is not to
the cabinet temperature of the top, side and bottom
be used for an extended period of time.rises considerably. To avoid burning yourself, do not
To disconnect the power cord, pull it out by thetouch the cabinet.
plug. Never pull the cord itself.
To prevent a malfunction, do not cover the ventilation
YShould any solid object or liquid fall into thehole for the cooling fan.
system, unplug the system and have it checked by
qualified personnel before operating it any further.On installing
YAC power cord must be changed only at theWhen you move the system, remove the CD.
qualified service shop.
On operation
YWhen you connect the power cord to a wall outlet,
even if the power is off, the system begins chargingIf the system is brought directly from a cold to a
for remote and timer functions. Therefore thewarm location, or is placed in a very damp room,
surface of this unit become warm, this is normal.moisture may condense on the lens inside the CD
player. Should this occur, the system will not operate
properly. Remove the CD and leave the system turned
on for about an hour until the moisture evaporates.
If you have any questions or problems concerning
your system, please consult your nearest Sony dealer.
continued
17 |
ACEC
