Presetting radio stations (continued)
Listening to the radio
To stop scanningN Preset Tuning
Press TUNING MODE on the remote.
Preset radio stations in the tunerOs memory first
To tune in a station with a weak(see OPresetting radio stations� on page 13).
signal
Press TUNING MODE on the remote1Press TUNER/BAND (or TUNER BAND
on the remote) repeatedly to select
repeatedly in step 2. OMANUAL � appears.OFM � or OAM �.
Then press TUNING � or + (or � or + on the
remote) repeatedly to tune in the station2Press TUNING MODE on the remote
manually and continue from step 4.repeatedly until OPRESET � appears.
To change the preset number3Press . or > to select the desired
preset station.
Start over from step 1.
To change the AM tuning intervalListening to non-preset radio
The AM tuning interval is factory-set to 9 kHzstations
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,Y Press TUNING MODE on the remote
then turn off the system. While holdingrepeatedly in step 2. OMANUAL � appears.
TUNING + on the system, turn the system backThen press TUNING � or + (or � or + on the
on. When you change the interval, all the AMremote) repeatedly to tune in the desired
preset stations are erased. To reset the interval,station (Manual Tuning).
repeat the same procedure.Y Press TUNING MODE on the remote
Tipsrepeatedly until OAUTO � appears in step 2
then press TUNING � or + (or � or + on the
YThe preset stations are retained for about a week
even if you disconnect the power cord or if a powerremote). The frequency indication changes
failure occurs.and the scanning stops when the system
YWhen a new station is memorized, the stationtunes in a station (Automatic Tuning).
formerly memorized at that preset number is erased.To cancel Automatic Tuning
Press TUNING MODE on the remote.
Tips
YIf noise is heard while listening to an FM station,
remove the FM antenna from the rear panel and
place the antenna outside the cabinet.
YTo improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
YWhen an FM stereo program has static noise, press
FM MODE on the remote repeatedly until
OMONO � appears. There will be no stereo effect,
but the reception will improve.
14 |
ACEC
