On cleaning
PrecautionsClean the cabinet, panel, and controls with a soft cloth
slightly moistened with a mild detergent solution. Do
On placementnot use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
Place the system in a location with adequate
If you have any questions or problems concerning your
ventilation to prevent heat build-up in the system.
system, please consult your nearest Sony dealer.
At high volume, over long periods of time, the cabinet
becomes hot to the touch. This is not a malfunction.
On cleaning discs
However, touching the cabinet should be avoided. Do
Do not use a commercially available CD/DVD
not place the unit in a confined space where
cleaning disc. It may cause a malfunction.
ventilation is poor as this may cause overheating.
Do not block the ventilation slots by putting anything
On your TV?s colour
on the system. The system is equipped with a high
If the speakers should cause the TV screen to have
power amplifier. If the ventilation slots on the top
colour irregularityt,h te TurnV at off once then turn it
surface are blocked, the unit can overheat and
on after 15 to 30 minutes. If colour irregularity should
malfunction.
persist, place the speakers farther away from the set.
Do not place the system on a soft surface such as a rug
that might block the ventilation holes on the bottom.
IMPORTANT NOTICE
Do not place the system in a location near heat
Caution: This system is capable of holding a still
sources, or in a place subject to direct sunlight,
video image or on-screen display image on your
excessive dust, or mechanical shock.
television screen indefinitely. If you leave the still
video image or on-screen display image displayed
On operation
on your TV for an extended period of time you risk
If the system is brought directly from a cpeoldrm atnoe ant dawarmma ge to your television screen.
location, or is placed in a very damp room, moisture
Projection televisions are especially susceptible to
may condense on the lenses inside the system. Should
this.
this occur, the system may not operate properly. In
this case, remove the disc and leave the system turned
On moving the system
on for about half an hour until the moisture
evaporates.When you carry the system, use the following
procedure to protect the inner mechanism. Remove the
When you move the system, take out any disc. If you
disc, and then press anxd hbuottldon on the the
don?t, the disc may be damaged.
system. After ?MECHA LOCK? is displayed on the
For power saving purposes, the system can be
front panel display, remove the AC power cord from a
completely turned of"/f1 bbyu thttoen on the
wall outlet.
system. Though the LED remains lit for a while, the
system is completely off.
On adjusting volume
Do not turn up the volume while listening to a section
with very low level inputs or no audio signals. If you
do, the speakers may be damaged when a peak level
section is suddenly played.
US
4 |
ACEC
