Step 1 Preparing the power supply
Charging the battery pack
Use the battery pack after charging it.
Your camcorder operates only with the OInfoLITHIUM� battery pack (L series).
(1) Open the DC IN jack cover and connect the AC Adaptor supplied with your
camcorder to the DC IN jack with the plugOs v mark facing toward the LCD
panel side.
(2) Connect the power cord to the AC Adaptor.
(3) Connect the power cord to a wall outlet.
(4) Set the POWER switch to OFF (CHG). Charging begins.
The remaining battery time is indicated in minutes on the display window.
When the remaining battery indicator changes to u, normal charge is completed. To
fully charge the battery (full charge), leave the battery pack attached for about one hour
after normal charge is completed until FULL appears on the display window. Fully
charging the battery allows you to use the battery longer than usual.
VCRPOWER
4
(CHG) OFF
1CAMERA
MEMORY
After charging the battery pack
Disconnect the AC Adaptor from the DC IN jack on your camcorder.
Note on the remaining battery time indicator
The remaining battery time indicator on the LCD screen/display window or in the
viewfinder indicates the recording time using the viewfinder. The indicator may not be
correct, depending on the conditions in which you are recording. When you close the
LCD panel and open it again, it takes about one minute for the correct remaining
battery time to be displayed.
Notes
YPrevent metallic objects from coming into contact with the metal parts of the DC plug of
the AC Adaptor. This may cause a short-circuit, damaging the AC Adaptor.
YKeep the battery pack dry.
YWhen the battery pack is not to be used for a long time, charge the battery pack once
10fully, and then use it until it fully discharges again. Keep the battery pack in a cool place. |
ACEC
