0 PHONES jack and controlINT/EXT (internal/external) switch and indicators
Connect stereo headphones with an impedance of 8This switch selects the time code used:
ohms, to monitor the sound during recording, playbackINT: The time code produced by the internal time
and editing.code generator.
The control knob adjusts the volume.EXT: The external time code selected as follows.
It is possible to make a setting so that the outputY When the TC switch is set to LTC or AUTO
volume from the MONITOR OUTPUT connectors isThe external time code input to the TIME CODE
Chapter 2Location and Function of Parts
controlled simultaneously.IN connector.
Y When the TC switch is set to VITC
In order that the output volume from the MONITORThe VITC time code included in the input video
OUTPUT connectors can be controlled simultaneously, an
signal.
internal board switch setting is required. For details, refer
to the Maintenance Manual Part 1.
PRESET/REGEN (preset/regenerated) switch and
indicators
!� Time code setting section
This switch makes the following selection for the
internal time code generator:
TC switch and indicators
PRESET: The initial value of the time code
INT/EXT switch and indicators
produced by the internal time code generator can
be preset by a control panel operation or by
PRESET/REGEN switch and indicators
remote control from a device connected to the
REMOTE1-IN(9P) connector.
TCTC GENERATOR
VITC
LTCREGEN: The internal time code generator is
AUTOINTPRESETFREERUNDFONsynchronized to the playback time code read by
REC
VITCEXTREGENRUNNDFthe internal time code reader.
The indicator corresponding to the selection lights.
FREE RUN/REC RUN switch and indicators
FREE RUN/REC RUN switch and
indicatorsThis switch selects the time code run mode of the
internal time code generator.
DF/NDF switch and indicators
FREE RUN: Regardless of the operating mode of
VITC switch and indicator
this unit, the time code value advances
continuously while the power is on.
REC RUN: The time code value advances only
TC (time code) switch and indicators
during recording. When this mode is selected, set
This switch selects the time code displayed in the
1)the INT/EXT switch to INT, and the PRESET/
lower control panel in the sequence: LTC n AUTO
2)REGEN switch to PRESET.
n VITC. The indicator corresponding to the
The indicator corresponding to the selection lights.
selection lights.
When AUTO is selected, the time code displayed is
VITC when the tape transport speed is up to half-
speed, and LTC when it is more than half-speed.
..........................................................................................................................................................................................................
1) LTC: abbreviation of Longitudinal Time code. This time2) VITC: abbreviation of Vertical Interval Time code. This
code is recorded on a longitudinal track on the tape.is inserted in the vertical blanking interval and recorded
Reading is unreliable at low speeds, and not possible aton the video tracks. It can be read at low speeds and
all during still playback.during still playback, but not during high-speed
playback.
Chapter 2 Location and Function of Parts2-5 |
ACEC
