SymptomCause/Remedy
When you set the AUDIO INPUT LEVELConfirm the level of the sound output from the player by referring to the playerOs
selector:instruction manual. According to that output level, set the AUDIO INPUT LEVEL
YYou do not know how to adjust the inputselector on the rear panel of this unit so as to obtain an optimum level. If you are
level.not clear about the playerOs output level, try the following procedure.
YThe recorded level is too low.1 Specify the output level by types of audio output connectors available on the
YThe recorded sound is distorted.player.
YIf the player is equipped with phono jacks: Set the AUDIO INPUT LEVEL
selector to �10.
YIf the player is equipped with XLR connectors: Set the AUDIO INPUT LEVEL
selector to +4 or �2.
2 Set the AUDIO INPUT switch on the front panel to FIX and play back the tape
which you intend to use for playback. When the playback audio level is at its
maximum, if the audio levels meters exceed 0 dB, set the AUDIO INPUT
LEVEL selector to the lower step (+4 or �2). Either, set the AUDIO INPUT
switch to VAR and turn the AUDIO REC LEVEL control knobs to adjust the
recording level. The recorded sound at the portion where the meters exceed 0
dB will be distorted.
The unit does not function as part of aYThe INPUT SELECT selector is set to a setting other than DV. t Set it to DV.
digital non-linear editing system.YThe editing controller or the editing software is not compatible with this unit. t
Refer to the instruction manuals of the controller or the software and consult
their manufacturers.
No picture on the LCD monitor.Y The CHARACTER DISPLAY (LCD) selector has been set to ON (BLACK
BACK). t Set it to ON.
YWith an analog connection, the current setting of the NTSC/PAL select switch is
not appropriate. t Set it to the appropriate position for the device you are
using.
Chapter 6 Maintenance
Chapter 6 Maintenance71 (GB) |
ACEC
