Location and Function of PartsLocation and Function of Parts
Front Panel
Chapter 1 Overview
1 Cassette lid
6 OPEN switch
5 POWER switch
1 Display window
(see page 11
(GB))
4 Monitor display
2 Tape transportsection (see
control sectionpage 16 (GB))
(see page 13
(GB))
4 LCD protection board
installation screw hole2 RESET button (bottom of unit)
(bottom of unit)
3 Carrying handle
3 Audio control section (see page 15 (GB))
1 Cassette lid5 POWER switch
To open the cassette lid, slide the OPEN switch 6 toPush up this switch to ON to turn on the power.
OPEN. The lid will click open. Raise the lid and insert
Note
a cassette.
For details of usable cassettes, see ONotes on VideoPower to the camera cable is not interrupted even if
Cassettes� on page 40 (GB).this switch has been turned off. If you are not going to
use the camera, turn off the power of the camera,
2 RESET buttondisconnect the camera cable and the DSR-50/50P AC
Press this button (bottom of unit) to initialize theadaptor, or remove the battery pack.
internal clock, all menu items and the time code of the
FREE RUN setting. Press this button with the tip of a6 OPEN switch
ball-point pen or similar tool.Slide this switch to the right (OPEN) to open the
cassette lid 1.
3 Carrying handle
Use the handle to carry the unit.
4 LCD protection board installation screw hole
Use this hole to install the LCD protection board
(supplied).
10 (GB)Chapter 1 Overview |
ACEC
