4-4 CUE Menu
4-4-5 Changing a Cue Point Into 4-4-6 Backspace Editing
an Edit Point
You can perform backspace editing with the CUE
Follow the procedure below to change any cue pointmenu. In backspace editing, assemble editing is
into an edit point.performed from the recording end point. Since the
data specifying recording end point are cleared when
To change an edit point into an IN pointyou eject the tape, after inserting a tape, you must
Press the SET button while hoding down the INrecord for at least one minute or so on the tape before
button.you can do backspace editing. After recording, the
present end of the recorded position becomes the
To change an edit point into an OUT pointrecording end point. When you press the AUTO
Press the SET button while holding down the OUTEDIT button afterwards, the VTR automatically
button.prerolls a few seconds before the recording end point
and starts assemble editing. If no data for the
Chapter 4 Menu SettingsTo change an edit point into an AUDIO INrecording end point exist, backspace editing is not
pointperformed.
Press the SET button while holding down the AUDIO
IN button.
To change an edit point into an AUDIO OUT
point
Press the SET button while holding down the AUDIO
OUT button.
AUDIO IN buttonAUDIO OUT button
IN button SET button
OUT button
4-32Chapter 4Menu Settings |
ACEC
