Chapter 3: Installing SecureSuite XS Workstation
Chapter 3: Installing SecureSuite XS Workstation
Prior to running the installer, please verify that you have at least one network client
installed on the target system. This can be verified by viewing the properties of
any available connection in Network Neighborhood or My Network Places
by right-clicking the connection icon and selecting Properties. If Client for
Microsoft Networks (or something similar) is not listed, click the Install or
Add button, then select Client and press OK. The list of available clients will then
be available. We highly recommend that you select Client for Microsoft
Networks. If no connection is available or established, please contact your
system administrator.
Installation
Important: Software installation requires local administrator privileges in the case
of a workstation-only setup, or domain administrator privileges for domain
installations. Before installing SecureSuite, close all applications and disable your
virus detection software.
Important: Please refer to the Sony? Puppy? installation guide (?Training Your
Puppy Unit?) included in your package or on the CD-ROM for specific instructions
on the installation and use of your fingerprint identity device.
To install SecureSuite:
1. Insert the SecureSuite CD into your CD-ROM drive. Wait
for the installation to start automatically.
2. If the software does not auto-initiate, select Start from the
taskbar and then click Run. In the Run dialog, type
D:\Setup.exe (where D is the drive letter for your CD-
ROM drive or other source media).
3. Follow the onscreen instructions, which are outlined below.
Welcome: Click Next to continue.
License Agreement: You must accept the terms of this license
agreement by checking the I accept the terms in the
license agreement check box to proceed with the
installation. Click Next to continue.
SecureSuite XS Workstation Guide 16 |
ACEC
