AUDIO OPERATIONS
Manual TuningPreset Tuning
This facility is used to store FM, AM broadcasting from
Channel 1 to 30 respectively.
POWER ON1 2 3 4
Automatic Memory Presetting
POWER ON1 2 4 3
Manual Tuning is generally used to tune to stations
broadcasting a signal that is too weak to be received
by Auto Tuning.
1. Select the TUNER function.
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
button.2. Select the AM or FM by pressing the BAND selector
button.
3. Press the TUNING MODE button to change to
TUNING mode.3. Press the MEMORY button for a while (for more than
(The Preset CH indicator disappears from the1.5 seconds).
display.)1 The start frequency will show in the display.
I87.5 MHz in FM, 522 kHz in AM.
4. When the UP or DOWN TUNING/PRESET button is2 The frequency and display will automatically scan.
pressed momentarily (0.5 second or less), the I50 kHz steps for FM, 9 kHz steps for AM.
frequency changes by a fixed step (see STEPS3 The frequency shown in the display will rapidly
below).change. As each station is located a preset
number will appear in the display indicating which
STEPSpreset MEMORY button has been assigned to the
FM: 50-kHz stepsstation located. The scanning process will
AM: 9-kHz stepscontinue to operate in this fashion until 30
stations have been found and entered into the
preset memory or when there are no more
stations to be found on the waveband chosen.
The memory indicator will extinguish and let you
hear the last station to be memorized.
I To listen to the memorized station select the band
required and press the TUNING/PRESET buttons.
4. The last memorized channel of each band will be
displayed when Auto Memory is completed. Check
the programmed frequencies with TUNING/PRESET
UP, DOWN button.
� 10 � |
ACEC
