Basic Settings
W_OUT (Word sync output frequency)
Select the frequency of the word sync signal. The factory
setting is O44.1�.
INPUTSETUP
100 aq 44.1 aq 88.2 aq 176(176.4) aq 48 aq 96 aq 192
< The word sync signal is output only when the WORD button
is set to OW`_OUT� (see page 14).
1Repeatedly press the SETUP button to select the menu
item to be changed.
CH (Channel)
When the i.LINK (AUDIO) terminal is connected to a digital
device, select the channels for this unit.
< If you leave the unit idle for 10 seconds, the setup mode willThe factory setting is L/R.
be cancelled.L/R: front left and right channels
C/LFE: center channel and LFE (subwoofer)
LS/RS: surround left and right channels
2Turn the INPUT knob to select the options within the< The icons of the selected channels light on the display.
menu item.
< Repeat steps and as 12required.i_RC (i.LINK remote control function)
When multiple AZ-1 units are directly connected using i.LINK
cables and you have this function on, the volume, muting and
dimmer of all AZ-1Os in the chain can be controlled using only
3Repeatedly press the SETUP button (or leave the unitthe L/R channel AZ-1.
idle for 10 seconds) to exit the setup mode.The linking of the control functions among the AZ-1s is
available as long as i.LINK cables are used to connect the AZ-1
units. You can use a different input type other than i.LINK if
you chose. If you do use a different input type, by also
connecting the AZ-1s with i.LINK cables you can control all
AZ-1s with only one unit as long as this function is switched
< Settings are stored even when power is turned off and theon.
unit is unplugged. If left unplugged for an extended period,
the settings may be lost.
With this remote control function switched off, the i.LINK
circuit is powered only when the input is set to i.LINK.
(Normal display)
Select this to exit the setup mode.
15 |
ACEC
