Cassette Deck Operation
Playback
1. Press the POWER switch ON.
2. Set the REV MODE switch to the
required tape travel mode.
3. Load a pre-recorded cassette with its
open edge facing down and side A fac-
ing toward you.
4. Select ON/OFF of the DOLBY NR system.
5. Press the or button to start play-
back.
6. Adjust the volume with the amplifier's8. Press the PAUSE (?) button again to
Recording
volume control.start recording.
O To stop playback, press the STOP ()O To stop recording temporarily, press the
button.1. Press the POWER switch ON.PAUSE (?) button. To restart the tape,
2. Set the REV MODE switch.press the PAUSE (?) button or play
O If you want to make a bi-directional( ) button. During the Record-
recording, set the REV MODE switch toPause mode, if the button whose ,
the A or o position.indicator is lit is pressed, recording will
Loading a Cassette Tape
O When starting to record with ú , onestart; however, if the button whose ,
1. Use your finger or a pencil to turn the
side recording is performed. indicator is not lit is pressed, only the
cassette's hub and take up any slack
O Set to the position if recording is totape direction will change; to restart the
tape.
be made on a single side of the tape.tape, press the button again.
Note: Avoid touching the tape.
3. Load a recordable cassette.O To stop recording, press the STOP ()
Fingerprints attract dust and dirt.
O Check that the safety tabs on the spinebutton.
2. Press the EJECT button (+)* to open
of the cassette are in place. If they have
the cassette compartment door.
been broken off, block the holes with
3. Load the cassette tape with its open
adhesive tape.
edge facing down.
4. Select the SOURCE switch.
4. Gently close the compartment door.Erasing
O When selecting "CD", the built-in CD
player's output is selected as a source.
O When selecting "LINE", the external sig-Anything previously recorded on the tape
nal from "LINE INPUT" is selected as awill automatically be erased when you
source.make a new recording on it. It can also be
5. Select ON/OFF of the DOLBY NR system.erased by "recording" on it with the INPUT
6. Press the RECORD button and the decklevel control set to "0".
enters the Record-Pause mode (REC
and ? indicators light).CAUTION
7. Adjust the recording level with theRecording pre-recorded tapes, records, or
INPUT level control so that the loudestother published or broadcast material may
sound to be recorded just makes theinfringe copyright laws. Check before
meters briefly reach around the "0 dB"recording.
point (for Normal or Chrome tapes) or
the "+3 dB" point (for Metal tapes).
Tape Counter
*Notes:
OThe cassette holder cannot beThe tape counter counts up when the tape
opened during recording or playback.is moving forward and down when the tape
OIf the power has been switched offis being rewound. The display can be
during play or recording, ejecting thecleared by pressing the COUNTER RESET
cassette may be impossible. In such abutton, which resets the counter index to
case, switch the power on and press"0000".
the eject button again.
_ _
11 |
ACEC
