Troubleshooting
If you have problems with your system, look through this chartBeware of condensation
and see if you can solve the problem yourself before calling yourWhen the unit (or a disc) is moved from a cold to a warm
dealer or TEAC service center.place, or used after a sudden temperature change, there is a
No powerdanger of condensation; vapor in the air could condense on
e Check the connection to the AC power supply. Check andthe internal mechanism, making correct operation erratic or
make sure the AC source is not a switched outlet and that,impossible. To prevent this, or if this occurs, leave the unit for
if it is, the switch is turned on. Make sure there is power toone or two hours with the power turned on. The unit will
the AC outlet by plugging another item such as a lamp orstabilize at the temperature of its surroundings.
fan into the outlet.
Remote control doesnOt work.Maintenance
e Press the POWER switch of the main unit to turn it on.If the surface of the unit gets dirty, wipe with a soft cloth or
e If the batteries are dead, change the batteries.use diluted mild liquid soap. Never spray liquid directly on this
e Use remote control unit within the range (5 m) and point atunit. Apply your cleaner to your cleaning cloth and wipe
the front panel.gently. Be sure to remove any excess completely. Do not use
e Clear obstacles between the remote control unit and thethinner, benzene or alcohol as they may damage the surface
main unit.of the unit. Allow the surface of the unit to dry completely
e If a strong light is near the unit, turn it off.before using.
No sound
e Check the connection to the amplifier.
e Check the operation of the amplifier.
Will not play.
e Load a disc with the playback side facing down.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded disc.
e Depending on the disc, etc. it may not be possible to play
back CD-R/RW discs. Try again with another disc.
e You cannot play back unfinalized CD-R/RW discs. Finalize
such a disc in a CD recorder and try again.
Sound skips.
e Place the unit on a stable place to avoid vibration and shock.
e If the disc is dirty, clean the surface of the disc.
e DonOt use scratched, damaged or warped discs.
If normal operation cannot be recovered, unplug the
power cord from the outlet and plug it again.
18 |
ACEC
