IMPORTANT SAFETY INSTRUCTIONS
CAUTION:"Note to CATV system installer:
? Read all of these Instructions.This reminder is provided to call the CATV system installer?s
? Save these Instructions for later use.attention to Section 820-40 of the NEC which provides guidelines for
? Follow all Warnings and Instructions marked on the audio proper grounding and, in particular, specifies that the cable ground
equipment.shall be connected to the grounding system of the building, as close
to the point of cable entry as practical."
1) Read Instructions ? All the safety and operating instructions
should be read before the product is operated.
2) Retain Instructions ? The safety and operating instructions
should be retained for future reference.Example of Antenna Grounding as per
3) Heed Warnings ? All warnings on the product and in theNational Electrical Code, ANSI/NFPA 70
operating instructions should be adhered to.
4) Follow Instructions ? All operating and use instructions should
be followed.
5) Cleaning ? Unplug this product from the wall outlet before
cleaning. Do not use liquid cleaners or aerosol cleaners. Use a dampANTENNA
LEAD IN
cloth for cleaning.WIRE
6) Attachments ? Do not use attachments not recommended by
the product manufacturer as they may cause hazards.GROUND
_CLAMP
7) Water and Moisture ? Do not use this product near water for
example, near a bath tub, wash bowl, kitchen sink, or laundry tub; inANTENNA
a wet basement; or near a swimming pool; and the like.DISCHARGE UNIT
(NEC SECTION 810-20)
8) Accessories ? Do not place this product on an unstable cart,
ELECTRIC
stand, tripod, bracket, or table. The product may fall, causing seriousSERVICE
injury to a child or adult, and serious damage to the product. UseEQUIPMENTGROUNDING CONDUCTORS
(NEC SECTION 810-21)
only with a cart, stand, tripod, bracket, or table recommended by theGROUND CLAMPS
manufacturer, or sold with the product. Any mounting of the product
POWER SERVICE GROUNDING
should follow the manufacturer?s instructions, and should use aELECTRODE SYSTEM
(NEC ART 250. PART H)
mounting accessory recommended by the manufacturer.NEC - NATIONAL ELECTRICAL CODE
9) A product and cart combination should be moved with care. Quick
stops, excessive force, and uneven surfaces may cause the product
and cart combination to overturn.
15) Lightning ? For added protection for this product during a
lightning storm, or when it is left unattended and unused for long
periods of time, unplug it from the wall outlet and disconnect the
antenna or cable system. This will prevent damage to the product
due to lightning and power-line surges.
16) Power Lines ? An outside antenna system should not be
located in the vicinity of overhead power lines or other electric light
or power circuits, or where it can fall into such power lines or circuits.
When installing an outside antenna system, extreme care should be
taken to keep from touching such power lines or circuits as contact
with them might be fatal.
17) Overloading ? Do not overload wall outlets, extension cords, or
integral convenience receptacles as this can result in risk of fire or
10) Ventilation ? Slots and openings in the cabinet are provided forelectric shock.
ventilation and to ensure reliable operation of the product and to18) Object and Liquid Entry ? Never push objects of any kind into
protect it from overheating, and these openings must not be blockedthis product through openings as they may touch dangerous voltage
or covered. The openings should never be blocked by placing thepoints or short-out parts that could result in a fire or electric shock.
product on a bed, sofa, rug, or other similar surface. This productNever spill liquid of any kind on the product.
should not be placed in a built-in installation such as a bookcase or19) Servicing ? Do not attempt to service this product yourself as
rack unless proper ventilation is provided or the manufacturer?sopening or removing covers may expose you to dangerous voltage
instructions have been adhered to.or other hazards. Refer all servicing to qualified service personnel.
? This product should be operated only from the type of power20) Damage Requiring Service ? Unplug this product from the
source indicated on the marking label. If you are not sure of the typewall outlet and refer servicing to qualified service personnel under
of power supply to your home, consult your product dealer or localthe following conditions:
power company. For products intended to operate from batterya) when the power-supply cord or plug is damaged.
power, or other sources, refer to the operating instructions.b) if liquid has been spilled, or objects have fallen into the product.
12) Grounding or Polarization ? This product may be equippedc) if the product has been exposed to rain or water.
with a polarized alternating-current line plug (a plug having oned) if the product does not operate normally by following the
blade wider than the other). This plug will fit into the power outletoperating instructions. Adjust only those controls that are covered by
only one way. This is a safety feature. If you are unable to insert thethe operating instructions as an improper adjustment of other
plug fully into the outlet, try reversing the plug. If the plug should stillcontrols may result in damage and will often require extensive work
fail to fit, contact your electrician to replace your obsolete outlet. Doby a qualified technician to restore the product to its normal
not defeat the safety purpose of the polarized plug.operation.
13) Power-Cord Protection ? Power-supply cords should bee) if the product has been dropped or damaged in any way.
routed so that they are not likely to be walked on or pinched by itemsf ) when the product exhibits a distinct change in performance _ this
placed upon or against them, paying particular attention to cords atindicates a need for service.
plugs, convenience receptacles, and the point where they exit from21) Replacement Parts ? When replacement parts are required,
the product.be sure the service technician has used replacement parts specified
14) Outdoor Antenna Grounding ? If an outside antenna orby the manufacturer or have the same characteristics as the original
cable system is connected to the product, be sure the antenna orpart. Unauthorized substitutions may result in fire, electric shock, or
cable system is grounded so as to provide some protection againstother hazards.
voltage surges and built-up static charges. Article 810 of the22) Safety Check ? Upon completion of any service or repairs to
National Electrical Code, ANSI/NFPA 70, provides information withthis product, ask the service technician to perform safety checks to
regard to proper grounding of the mast and supporting structure,determine that the product is in proper operating condition.
grounding of the lead-in wire to an antenna discharge unit, size of23) Wall or Ceiling Mounting ? The product should be mounted to
grounding conductors, location of antenna-discharge unit,a wall or ceiling only as recommended by the manufacturer.
connection to grounding electrodes, and requirements for the24) Heat ? The product should be situated away from heat sources
grounding electrode.such as radiators, heat registers, stoves, or other products
(including amplifiers) that produce heat.
� 2 � |
ACEC
