W_OUT (Word sync output frequency)Low-pass analog filter (80kLPF)
Select the frequency of the word sync signal. The factoryThe use of this filter produces a subtle difference in sound
setting is O44.1k�.directivity. Switch this filter on or off (default) depending on
your preference.
< The word sync signal is output only when the WORD button
is set to OOUT�.With this filter switched off, there is a chance that unexpected
and abnormal noise could be produced and harm your
Normal Modespeakers or trip the protection circuit on your power amplifier.
44.1k88.2k176.4kTo protect your system it is recommended that this filter be
switched ON.
100k192k96k48k
4% Down Mode
48P(46.08k)96P(92.16k)
IEEE 1394 remote control function (1394RC)
100P(96k)192P(184.32k)
When multiple D-01 units are directly connected using IEEE
(OP� means O4% down mode for PAL film�)
1394 cables and you have this function on, the functions of
all D-01Os in the chain can be controlled using only the left
channel D-01. The P-01 source should be the first machine in
the IEEE 1394 chain followed by all the D-01Os. (Do not
CH_SEL (Channel Select)connect the P-01 between the D-01 units.)
Select the channel for this unit.
The linking of the control functions among the D-01s is
LR
CENTER
(Front L)(Front R)available as long as IEEE 1394 cables are used to connect the
D-01 units. You can use a different input type other than
RSLSLFE
IEEE 1394 if you chose. If you do use a different input type,
(Right Surround) (Left Surround)(Subwoofer)
by also connecting the D-01s with IEEE 1394 cables you can
control all D-01s with only one unit as long as this function is
< The icon of the selected channel lights on the display.switched on.
With this remote control function switched off, the IEEE 1394
circuit is powered only when the input is set to IEEE 1394.
< The icon will blink if the channel you set here differs from the
channel of the input signal. In this case, select the proper
channel again, or check the connection to the digital device.
Dimmer
The display and indicators can be dimmed to suit the
environment in which you listen to music. There are three
DSDlevels and an Ooff� setting.
Used to select a sampling rate (Fs) to convert DSD to PCM.
< In OFF mode, when you press any button, the illuminations
88.2 k (factory setting) or 176.4 k are available.
turn temporarily on.
< Note that the OFF setting is not memorized when the power
DSD gain
is turned off. When the unit is switched off with the display
Used to select a level for DSD-PCM conversion. 0 or +6off, and then turned on again, the display is reset to the
(factory setting) are available.minimum brightness (Dimmer1).
< The factory setting is ODimmer3�.
< With the DSD set to 176.4 kHz and the DSD gain to +6, there
is a chance that the sound will be distorted when playing
back discs on which music is recorded at very high volume
levels. If this is the case, set Othe DSD to 88.2 kHz and the
DSD gain to +6� or Othe DSD to 176.4 kHz and the DSD gain
to 0�.
< When the DSD gain is set to 0, Super Audio CD discs are
played back at a lower level than CDs are.
13 |
ACEC
