Discs
Discs which can be played on this unit:< Never use such chemicals as record sprays, antistatic sprays or
Y Conventional audio CDs bearing the CD-DA logo on thefluid, benzine or thinner to clean the discs. Such chemicals
label:will do irreparable damage to the discOs plastic surface.
< Discs should be returned to their cases after use to avoid dust
and scratches that could cause the laser pickup to Oskip.�
Y Properly finalized CD-R and CD-RW discs
< Do not expose discs to direct sunlight or high humidity and
temperature for extended periods. Long exposure to high
Note:
temperatures will warp the disc.
< Depending on the quality of the disc and/or the condition of
the recording, some CD-R/CD-RW discs may not be playable.
< Do not play any disc that is warped, deformed or damaged.
Playing such discs may cause irreparable harm to the playing
< Copy-protected discs and other discs which do not conform
mechanisms.
to the CD standard may not play back correctly in this player.
If you use such discs in this unit, TEAC Corporation and its
< CD-R and CD-RW discs are more sensitive to the effects ofENGLISH
subsidiaries cannot be responsible for any consequences or
heat and ultraviolet rays than ordinary CDs. It is important
guarantee the quality of reproduction. If you experience
that they are not stored in a location where direct sunlight
problems with such non-standard discs, you should contact
will fall on them, and away from sources of heat such as
the producers of the disc.
radiators or heat-generating electrical devices.
< Printable CD-R and CD-RW discs arenOt recommended, as the
label side might be sticky and damage the unit.
< Do not stick papers or protective sheets on the discs and do
< Always place the disc on the disc tray with the label side up.not use any protective coating spray.
(Compact discs can be played or recorded only on one side.)
< Use a soft oil-based felt-tipped pen to write the information
< To remove a disc from its storage case, press down on theon the label side. Never use a ball-point or hard-tipped pen,
as this may cause damage to the recorded side.
center of the case and lift the disc out, holding it carefully by
the edges.
< Never use a stabilizer. Using commercially available CD
stabilizers with this unit will damage the mechanisms and
cause them to malfunction.
< Do not use CDs with an irregular shape (octagonal, heart
shaped, business card size, etc.). CDs of this sort can damage
How to remove the discHow to hold the disc
the unit:
< Should the disc become dirty, wipe the surface radially (from
the center hole outward towards the outer edge) with a soft,
dry cloth:
< If you are in any doubt as to the care and handling of a CDR/
CD-RW disc, read the precautions supplied with the disc, or
contact the disc manufacturer directly.
5 |
ACEC
