Remember�
Questions andAnswers
For television
operation queries,
please ring the
helpline�
?
Below are the answers to some of the most common queries.
For more information go to www.toshiba.co.uk
Why is there a message permanently on the
Why is there no sound or picture?
QQscreen?
Check the mains switch is on and check allRemove it by pressing CALL.
Aconnections. A
Check the television is not in standby mode.
Why are there problems with teletext?
Q
Why doesnOt the video/DVD being played show
Qon screen?
Good performance of text depends on a good strong
Abroadcast signal. This normally requires a roof or loft
Make sure the VCR or DVD player is connected to
aerial. If the Text is unreadable or garbled, check the aerial.
Athe television as shown on page 6, then select the
correct input by pressing B.Go to the main indexpage of the teletext service and look
for the User Guide. This will explain the basic operation of
teletext in some detail. If further information is needed on
how to use text see the teletext section.
Why is there a good video picture but no sound?
Q
There is a picture, but why is there little or no
Check the SCART lead connection.
Q
Acolour?
When using an external source, for instance, a
Apoor quality video tape, if there is little or no
Why is there a picture but no sound?
Qcolour, improvements may sometimes be achieved. The
colour is factory set to AUTO to automatically display the
Check the volume has not been turned down orbest colour system.
Athat sound mute has not been selected.
To check that you have the best colour:
Select Colour from the Manual setting menu.
What else can cause a poor picture?1
Q
Manual setting
Interference or a weak signal. Try a different
Colour : AUTO
Atelevision station. Manual fine tuningmay help.
EXT1 A VCR
Why is the VCR/DVD picture in black and
Qwhite?
OK: To store
Check the correct input has been chosen, MENU : To return
AS-VIDEO or Video. See AVconnections.EXIT : To exit
With Sor Rchoose between AUTO, PAL,
2
Why doesnOt the remote control work?SECAM, NTSC 4. 43 or 3. 58.
Q
Check the batteries arenOt dead or insertedWhere there is loss of colour, picture or the
Aincorrectly.Qposition moves, how can this be restored?
Switch the television off and wait for the red led to
Why donOt the controls on the front of the
Aextinguish before switching back on. If the problem
Qtelevision work?
persists contact the Helpline.
Check that Panel Lock is not ON.
A
19 |
ACEC
