69_77_Function Setup_EN.fm Page 74 Friday, July 13, 2007 5:36 PM
DisplayVideo
1In stop mode, press [SETUP]. Select 1In stop mode, press [SETUP]. Select
?General Setting? using [U / D], ?General Setting? using [U / D],
then press [ENTER/OK].then press [ENTER/OK].
2Select ?Display? using [U / D], then 2Select ?Video? using [U / D], then
press [ENTER/OK].press [ENTER/OK].
General SettingGeneral Setting
PlaybackPlayback
DisplayDisplay
VideoVideo
RecordingRecording
ClockClock
ChannelChannel
DivXDivX
HDMIHDMI
Reset AllReset All
3Select the desired item using 3Select the desired item using
[U / D], then press [ENTER/OK].[U / D], then press [ENTER/OK].
1Screen Saver1TV Aspect
2FL Dimmer2Select Video
3Video Out
4Refer to 1. and 2. on this page and
4Refer to 1. and 3. on this page and
set the selected item.
set the selected item.
5When you finish with the setting, For 2., refer to page 44.
press [SETUP] to exit.
5When you finish with the setting,
press [SETUP] to exit.
1. Screen Saver (Default: 10 minutes)
Set the screen saver time delay.
1. TV Aspect (Default: 16:9 Wide)
Select a setting using [U / D], then You can select the TV aspect ratio to match the
press [ENTER/OK].formats of what you are playing back with the unit and
your TV screen (4:3 standard or 16:9 widescreen TV).
Screen Saver
OFFSelect the desired setting using
5 minutes
[U / D], then press [ENTER/OK].
10 minutes
15 minutes
30 minutesTV Aspect
4:3 Letter Box
Your setting is activated.4:3 Pan & Scan
16:9 Wide
2. FL Dimmer (Default: Bright)
If you have a standard TV:
Set the front panel display brightness.Select ?4:3 Letter Box?, so that black bars appear on
the top and bottom of the TV screen when playing
Select a setting using [U / D], then
back a wide-screen picture. Select ?4:3 Pan & Scan?
press [ENTER/OK].
for a full height picture with both sides trimmed when
FL Dimmerplaying back wide-screen picture.
AutoIf you have a widescreen TV:
Bright
Select ?16:9 Wide?.
Dark
You can choose one from ?Auto?, ?Bright? or 3. Video Out (Default: SCART(RGB))
?Dark?.This unit is compatible with the Progressive Scan
If ?Auto? is selected, the display gets dark when System. The feature provides you with the higher
the power is off.definition images than the traditional output system
does. You can enjoy Progressive Scan image by
using HDMI OUT or COMPONENT VIDEO OUTPUT.
To utilise the Progessive Scan system through the
COMPONENT VIDEO OUTPUT, you must set Video
Output mode in the Setup menu by following the steps
on next page. ?SCART (RGB)? is selected as the
default.
74EN |
ACEC
