Fig. 4Fig. 8
If after having car-Position the runners
ried out the opera-H(H) inside the kitch-
A
tion just describeden unit door as
there is still someshown in Fig. 8 and
space left betweenmark the position of
the appliance andthe external holes.20mm
the kitchen unit, ŢtAfter preparing the
the trimming pro-holes, screw the
vided together withrunners to the
D265the appliance, onD094kitchen unit door
the stop strip (A).using 3.5x16 mm
screws.
Fig. 5
Fig. 9
Open the door and8mm
push the applianceOpen both the ap-
against the side ofpliance door and
the kitchen furni-that of the kitchen
ture opposite tounit to approx. 90°.
that of the appli-Place the little
ance hinges.Dplates over the run-
Fasten the appli-ners.
ance with 4 screwsHold the doors of
Cprovided in the kitD032the appliance and
included with thePR34the unit together
appliance.and mark the holes.
Snap vent grill (C) and hinge cover (D) into position.Fig. 10
Fig. 6
Remove the little
Press in the jointplates and make the
covers betweenholes with a diam. of
the appliance and2 mm. Replace the
the kitchen unit.little plates over the
runners and screw
in the screws pro-
vided (3.5x16 mm).
If the kitchen unit
PR35door needs to be re-
D030aligned, adjust the
position of the
Fig. 7screws in the slots.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Apply covers (B)
on joint cover lugs
and into hinge
holes.
B
D096
14 |
ACEC
