NC
AFTERîSALES SERVICE
Before you call the Afterîsales Service:
1. Reîstart the cooking hob, to check whether
correct operation has been restored.
2. If the malfunction persists, call the Afterîsales
Service.
Give the following information:
xtypeofmalfunction;
xmodelofcookinghob;
xservicenumber�i.e.,thenumberthatfollows
the word SERVICE on the rating plate under
the cooking hob and on the guarantee paperO;
xyourcompleteaddress;l
xyourtelephonenumberandareacode.
INSTALLATION
Technical information for installerxBeforeinstallingthecookinghob,removethe
plastic film that protects it, if present.
This cooking hob can be embedded in aThe outer surfaces of the furniture or appliances
worktop 20 to 50 mm thick.
adjoining the cooking hob must be heat resistant
If another appliance is not fitted under the�heat protection oYó, according to standards EN
cooking hob, insert a separator panel, at a
60335î2î6O.
distance of at least 90 mm from the cooking
hob bottom.xInstallationmustcomplywithcurrentlocalsafety
regulations.
xIfaverticalpieceoffurnitureisinstalled,
there must be a gap of at least 100 mm
between it and the edge of the cooking
hob.
Installation of cooking hob
xApplythesuppliedgaskettothecooking
hob �unless it has already been fittedO, after
having cleaned its surface as shown in the
figure.a
AîIftheworktopismadeoutofwood,use
the springs supplied.
1. Fit the 4 springsa into the relevant seat under
the box.
2. Make an opening in the worktop, respecting the
dimensions indicated in the enclosed product
description sheet.
3. Install the cooking hob in the worktop.
BîIftheworktopismadeoutofmarbleor
other materials �plastics, ceramics or stoneO, the
cooking hob must be fixed by means of brackets
b,tobeorderedfromtheAfterîSalesService
�code 4819 310 18528O.
1. Align the brackets with the bores and fix them
with the screws.
2. Make an opening in the worktop, respecting the
dimensions indicated in the product description
sheet.
3. Install the cooking hob in the worktop.
56
MY
56 |
ACEC
