Using Your Refrigerator
Continued
Changing the light bulbs
To change refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind the Control Console to find
bulb(s).
3. Remove bulb.
4. Replace with a 40-watt appliance bulb.
!j. Reconnect power supply.
NOTE: Not all commercial appliance bulbs will fit
your refrigerator. Be sure to replace bulb with one
of the same size and shape.
Reversing the door swing
You can change the hinges on your refrigerator so
the doors open the other way. Refer to the instruc-
tions sheet included with your refrigerator.
Ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends.
3. Twist slightly.
Optional automatic ice maker
If you have the automatic ice maker accessory, or
if you plan to add one later (Part No. ECKMF-90),
there are a few things you will want to know:
l The ON/OFF lever is a wire signal arm.
Down...for making ice automatically.
Up...to shut off the ice maker,
NOTE: Do not turn ice maker on until it is
connected to the water supply. Instructions
for ice maker water supply n ?look-up are
attached to the back of the r efriqerator
cabinet.
. The dial or lever on the side of the ice maker
changes the size of the cubes.
l Shake the bin occasionally to keep cubes sepa-
rated and to obtain increased storage capacity.
. It is normal for ice crescents to be attached by a
corner. They will break apart easily.
8 |
ACEC
