WASHER USE
SUPER CAPACITY PLUS WASHERS
Understanding Washer Cycles
When the washer lid is closed and the Cycle Control knob is set Heavy Work Clothes
to a number or cycle and pulled out, the washer Ţlls (to the 3 pair pants1 coverall
selected load size) before agitation and timing start. The washer 3 shirts1 overall
begins agitating immediately after Ţlling; agitation occurs with the
4 pair jeans
washer lid down.
During agitation, the agitator creates a continuous rollover action Delicates
(on some models) that provides a thorough cleaning of the wash 3 camisoles2 bras
load.1 quilted robe2 nighties
4 slips1 babyOs dress
4 panties
Towels
10 bath towels14 washcloths
10 hand towels1 bath mat
After agitation starts, the Cycle Control knob turns clockwise until
Mixed Load
it points to an OFF area and the cycle ends.
3 double sheets2 shirts
NOTE: The washer pauses brie�y throughout each cycle. These
4 pillowcases2 blouses
pauses are normal for washer operation.
8 T-shirts8 handkerchiefs
WASHRINSE6 pair shorts
1.Fill1.Fill
EXTRA LARGE CAPACITY WASHERS
Heavy Work Clothes
2 pair pants3 pair jeans
2.Wash2.Rinse3 shirts1 coverall
selected time
Delicates
3 camisoles2 bras
4 slips2 nighties
 Â
3.Drain3.Drain
4 panties
No agitationNo agitation
Towels
8 bath towels10 washcloths
8 hand towels1 bath mat
4.Spin4.Spin-Spray rinse
Mixed Load
2 double sheets or6 pair shorts
1 king size sheet2 shirts
5.Spin
4 pillowcases2 blouses
6 T-shirts6 handkerchiefs
 6.OffNormal Sounds
The Casual/Permanent Press
cycle partially drains, Ţlls, Your new washer may make sounds your old one didnOt. Because
agitates brie�y, and drains.the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
During washing
When you select a small load size setting, your washer has a
Loadinglower water level. This can cause a clicking sound from the upper
For rated load capacity, refer to the model and serial label/plate, part of the agitator.
located on your washer as shown in OParts and Features.�During drain
Loading suggestionsIf water is drained quickly from your washer (depending on your
For these suggested full-sized loads, set the LOAD SIZE selector installation), you may hear air being pulled through the pump
to the highest load size setting.during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
5 |
ACEC
